Joy-it SEN-KY052 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Joy-it SEN-KY052 (9 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
www.joy it.net-
Pascalstr. 8 47506 Neukirchen Vluyn-
TEMPERATURE AND AIR PRESSURE SENSOR
SEN KY052-
1. GENERAL INFORMATION
Dear customer,
Thank you very much for choosing our product. In the following we will
show you what has to be observed during commissioning and use.
Should you encounter any unexpected problems during use, please feel
free to contact us.
www.joy it.net-
Pascalstr. 8 47506 Neukirchen Vluyn-
2. USAGE WITH THE RASPBERRY PI
2.1 Installation
First you need to install git and pip on your Raspberry Pi, this works with
the following commands:
sudo apt get install git-
Now you can download and install the required librarys for the sensor as
follows:
sudo pip3 install adafruit circuitpython bmp280- -
sudo apt get install python3 pip- -
sudo pip3 install adafruit circuitpython lis3dh- -
2.1.1 Installation SPI
To use the sensor with SPI, you must first activate the SPI interface.
To do this, enter the following command:
sudo raspi config-
Now navigate to 3 Interfacing Options -> P4 SPI and enable the SPI in-
terface.
Now you need to reboot your Raspberry Pi with the command:
sudo reboot
Now open the configuration of the Raspberry Pi and activate I2C as
follows:
sudo raspi config-
sudo apt get install y python smbus - - -
sudo apt get install y i2c tools - - -
Now enter the following commands for installing the I2C interface:
2.1.2 Installation I2C
Now navigate to and enable the I2C inter-3 Interface Options -> P5 I2C
face.
www.joy it.net-
Pascalstr. 8 47506 Neukirchen Vluyn-
Raspberry Pi KY052
3.3 V
(Pin 1, Pin 17) VCC, SDO, CSB
GND (Pin 6) GND
SCL SCL(Pin 5)
SDA SDA(Pin 3)
2.2.1 Wiring I2C
2.2.2 Wiring SPI
Raspberry Pi KY052
3.3 V
(Pin 1, Pin 17) VCC
GND (Pin 6) GND
SCLK SCL(Pin 23)
MOSI SDA(Pin 19)
Pin 29 CSB
MISO (Pin 21) SDO
2.3 Programming example
In the following programme example, the temperature, the air pressure
and the calculated altitude are shown.
In order for the altitude to be calculated correctly, the following line in
the programme example must be adjusted:
Replace the 1013.25 with the QNH pressure in hPa (the pressure at sea
level) at your location. Weather services can give you information on this.
sensor.sea_level_pressure = 1013.25


Product specificaties

Merk: Joy-it
Categorie: Niet gecategoriseerd
Model: SEN-KY052

Heb je hulp nodig?

Als je hulp nodig hebt met Joy-it SEN-KY052 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Joy-it

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd