PAC AP4-TY14 Handleiding

Bekijk gratis de handleiding van PAC AP4-TY14 (5 pagina’s), behorend tot de categorie Keverőgép. Deze gids werd als nuttig beoordeeld door 27 mensen en kreeg gemiddeld 5.0 sterren uit 4 reviews. Heb je een vraag over PAC AP4-TY14 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

© 2024 Stinger Solutions

C

Page 1

Rev: 1

Date:09242024

Advanced Amplier Interface

for Select Toyota Applications

AP4-TY14

The AP4-TY14 provides a 6-channel pre-amp output for use with aftermarket audio equipment. Using the full range

xed level head unit output, in conjunction with data bus messages, the AP4-TY14 delivers a variable 5v RMS pre-

amp output with fading, balance, equalization, and level control capabilities. The module also retains audio from

other vehicle features such as factory navigation prompts, Bluetooth and Voice Activation. An accessory controlled

remote amplier turn on wire is also provided by the AP4-TY14. When used in conjunction with the APA-TOS1 (sold

separately), the module can provide a variable 2-channel ber optic digital audio output (TOSLINK).

Introduction and Features

Important Notes

1. Toyota Safety Connect (SOS) can easily be retained. See the page 3 for detailed instructions.

2. The aftermarket amplier must have a very solid ground and the amplier power/ground connections should be made

before connecting the RCA's or Remote on the AP4-TY14.

3. The factory radio's speed controlled volume, DSP, and surround sound mode are not supported by the AP4 outputs.

4. The factory amplier must remain connected and in the vehicle after the AmpPRO has been installed.

5. Prior to testing, cycle the ignition off and back on again to properly initialize the AP4-TY14.

6. The radio's beep setting must be enabled on the factory radio in order to hear the audible tones when making selections

through the radio.

7. Initially, if the beep through the AP4-TY14 does not match the on/off selection through the radio, cycle the beep to the

opposite setting and back, then test again.

8. The radio's beep volume and minimum volume levels are set to 0 dB by default. If you are happy with this level in your

particular application, additional adjustment is not required. Please refer to the Setup and Conguration section on page 4

for more details.

9. The Radio's Nav / VR Voice, incoming E-mail tone, Ringtone, In-Call, Incoming SMS / MMS tone and Incoming SMS Voice

volumes can be adjusted through the radio's settings menu as they were prior to installation of the AP4-TY14.

10. The remote output is rated at 2A of current. If more current is needed, an external relay must be used.

11. Channels 5 and 6 are non-fading outputs. The output level of channels 5 and 6 can be controlled using the supplied level

control knob.

Wiring Connection Chart

To Aftermarket

Amplier

Non-FadingRearFront

1(L)2(R)4(R)5(L)6(R)3(L)

Non-Fading

Level Control

Knob

Remote Turn On Output (2A Max)

SOS Mute ( - Trigger Input )

GRAY

GRAY

BLACK

BLACK

WHITE

WHITE

28-pin

10-pin

30-pin

Product specificaties