SkyRC e3 Handleiding

Bekijk gratis de handleiding van SkyRC e3 (2 pagina’s), behorend tot de categorie Batterij-oplader. Deze gids werd als nuttig beoordeeld door 11 mensen en kreeg gemiddeld 4.1 sterren uit 5 reviews. Heb je een vraag over SkyRC e3 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

WARRANTYANDSERVICE

We guarantee this product to be free of manufacturing and assembly defects for a period of one

year from the time of purchase. The warranty only applies to material or operational defects,

which are present at the time of purchase. During that period, we will repair or replace free of

service charge for products deemed defective due to those causes. For any repair or replace

service, please contact your dealer in the first instance, who is responsible for processing

guarantee claims.

Thiswarrantyisnotvalidforanydamageorsubsequentdamagearisingasaresultofmisuse,

modificationorasaresultoffailuretoobservetheproceduresoutlinedinthismanual.

WARNING AND SAFETY NOTES

This appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if

they have been given supervision or instruction concerning use of the appliance in a safe

way and understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similar qualified persons in order to avoid a hazard.

This charger is suitable for charging rechargeable LiPo batteries. Do not attempt to

recharge non-rechargeable batteries. Charging other types of batteries may cause fire or

explosion.

Never leave the charger unattended when it is connected to its power supply.

The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.

Protect charger from dust, dirt and damp.

Never place the charger and batteries connected to it on any form of flammable surface.

Never operate the charger in the vicinity of inflammable material or gas.

During charging, the battery must be placed in a well ventilated area . Never place the

charger on a carpet or similar surface.

Take great care to maintain correct battery polarity, and avoid shot-circuit. Read the battery

manufacturer's instructions and adhere to them strictly.

The charger must only be plugged into an earthed socket-outlet (for portable class 1

battery chargers for outdoor use)

The connection to the supply mains is to be in accordance with the national wiring rules

when battery chargers for installation in caravans and similar vehicles.

INSTRUCTION MANUAL

SK-100081

Thank you for your choice of the SKYRC e3, 100-240V AC balance charger. This unit is simple to

use but its operation does require some knowledge on the part of the user. Please read this entire

operating manual completely and attentively before using this product, as it covers a wide range of

information on operating and safety.

SKYRC e3 Charger is an economic, high quality 100-240V AC balance charger, designed for

charging LiPo batteries from 2-3 cells in balance mode. The circuit power is 11W and max charge

current can reach to 1.2A.

INTRODUCTION

CHARGE PROCEDURES

SKYRC e3 comes with the built in power supply. You can connect the AC power cord to the

AC socket (100-240V AC) directly.

Insert the AC power cord into the charger.

Insert the AC cord into a wall socket (100-240V). All LEDs will light green and flash red to

indicate the charger is ready to charge.

Connect battery balance wire to balance port which is in front side of the charger, after 2

seconds, the charger detects the voltage of the battery and starts to charge.

The charger starts charging. The LEDs will glow constant red. If the battery pack is 2-cell, Cell 1

and Cell 2 LEDs will glow constant red; if the battery pack is 3-cell, Cell 1, Cell 2 and Cell 3

LEDs will glow constant red.

When a cell is completely charged, its corresponding LED will glow constant green. A 2-cell

pack is fully charged when LEDs 1 and 2 are constant green. For 3-cell pack, all LEDs will glow

constant green to indicate the pack is fully charged.

Unplug the battery from the charger and the charge status LED will stay green and flash red

which indicates the charger is ready to charge another battery.

Please refer to following steps to charge the battery,

1)

2)

3)

4)

5)

6)

2-Cell Balance Port

3-Cell Balance Port

Cell 1 LED Indicator

Cell 2 LED Indicator

Cell 3 LED Indicator

AC 100-240V

PowerJack

Ver. 2

Note: Please DON'T connect more than one battery to the balance ports

simultaneously. ONE battery is allowed to connect to the balance port at a

time and this charger can charge ONE battery at a time.

- 1 -- 2 -

Product specificaties