Princeton Tec EOS II Handleiding

Bekijk gratis de handleiding van Princeton Tec EOS II (2 pagina’s), behorend tot de categorie Zaklamp. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.5 sterren uit 7 reviews. Heb je een vraag over Princeton Tec EOS II of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PRINCETON TEC EOS II FOR USE IN HAZARDOUS LOCATIONS

ONLY AS TO INTRINSIC SAFETY.

3PRJ

CL I, DIV 1, GR A, B, C, D. TEMP CODE T4. Exia.

WARNING – SUBSTITUTION OF COMPONENTS MAY IMPAIR INTRINSIC SAFETY.

WARNING – TO PREVENT IGNITION OF FLAMMABLE OR COMBUSTIBLE

ATMOSPHERES, DISCONNECT POWER BEFORE SERVICING.

WARNING – TO REDUCE THE RISK OF IGNITION OF A FLAMMABLE OR

EXPLOSIVE ATMOSPHERE, CHANGE BATTERIES ONLY IN AN

AREA KNOWN TO BE NON-HAZARDOUS.

WARNING - TO REDUCE THE RISK OF EXPLOSION; DO NOT MIX OLD

BATTERIES WITH USED BATTERIES, OR MIX BATTERIES FROM

DIFFERENT MANUFACTURERS.

APPROVED FOR USE WITH THREE 1.5V AAA BATTERIES, DURACELL MN2400

OR ENERGIZER E92.

Princeton Tec cares about the environment and

recommends recycling batteries. For more information

about battery recycling, please go to:

www.batteryrecycling.com

Observe proper battery polarity when installing the

batteries. Improper installation of the batteries will

damage the light and void the warranty.

• Never mix fresh and used batteries.

• Never mix different battery brands or

chemistry types.

• Always remove drained batteries immediately.

• Remove batteries during long periods of

storage.

NOTE: Lithium batteries offer extended

constant brightness time, extreme cold

weather performance, and are lighter weight.

Rechargeable NiCad or NiMH batteries may

result in reduced brightness due to lower

nominal voltage.

The EOS II battery compartment has a

waterproof seal. It is important to keep this seal

free from dirt and away from harsh chemicals in

order to preserve waterproof integrity. Inspect

the seal every time batteries are changed. If dirt

is present, wipe gently with a damp cotton

swab and mild soap until dirt is removed.

NOTE: Some battery types can emit hydrogen

gas, which can create an explosion potential in

sealed devices if it is not vented or removed.

The EOS is equipped with a platinum catalyst

to remove this gas. Upon severe impact, the

catalyst could fracture. If you notice a rattling

sound in the headlamp or gray particles in the

battery compartment, do not use the

headlamp. See the warranty and return policy

for more information.

Switch Operation - See Switch Operation

Diagram

Modes (High and low) are selected by pressing

and releasing the button within 1.5 seconds of

the previous button press.

To turn the EOS II off, press and hold until the

light turns off.

Troubleshooting

If the EOS II fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is

confirmed.

• Check circuit board for water (the seal may

have been compromised by improper rear

cover installation). The light will resume

normal operation once the water is shaken or

blown out and the light is left open until

completely dry. If the light has been

contaminated with salt water, flush the unit

with fresh water and dry as described above.

USA Lifetime Warranty - International

10-Year Warranty

Due to International regulations, Princeton

Tec's lifetime warranty can only be offered to

customers in the USA. Princeton Tec offers a

10-year warranty to our customers outside the

USA. FULL WARRANTY - Princeton Tec

warrants this product to be free from defects in

workmanship and materials under normal use

for as long as you own this product. This

warranty covers all of the component parts of

the product except batteries. This warranty

does not cover deterioration due to normal

wear or damage due to misuse, alteration,

negligence, accidents, or unauthorized repair.

Princeton Tec will repair or replace parts which

are defective In workmanship or materials. Your

authorized Princeton Tec Dealer and Princeton

Tec are the only facilities authorized to repair

the product. After (3) unsuccessful attempts to

repair the product, you have the right to elect

replacement of the product

or a refund of the purchase price less

allowance for use of the product. NO

INCIDENTAL OR CONSEQUENTIAL DAMAGES

ARE INCLUDED IN THIS WARRANTY. (Some

states do not allow the exclusion or limitation of

incidental or consequential damages, so the

above limitations or exclusions may not apply

to you.)

This warranty gives you specific legal rights,

and you may also have other rights which vary

from state to state.

Princeton Tec reserves the right to change

product specifications without notice.

FOR CALIFORNIA RESIDENTS:

WARNING: This product contains Bisphenol A

(BpA) a chemical known to the State of

California to cause birth defects or other

reproductive harm.

Return Policy

If your light fails to operate, follow these

simple steps:

1) Check batteries. Replace if necessary.

2) To send your light in for repair or

replacement, first contact Princeton Tec

customer service on to 1-800-257-9080

request an RMA number. Please have your

light model, date of purchase and a brief

description of the fault you are experiencing.

No warranty repairs will be accepted without

an RMA number.

3) Return the light without batteries to:

Princeton Tec, PO Box 8057 Trenton NJ

08650 Postage due and freight collect

items will not be accepted.

4) Upon receipt your light will be processed in

about two weeks. Please allow additional

time for return transportation from New Jersey.

INTRINSICALLY SAFE

LED HEADLAMP

•Alkaline (LR03)

• LITHIUM (L92)

• Lithium batteries may be used,

but have not been approved by UL

0324

Princeton Tec

PO Box 8057, Trenton,

NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

princetontec.com

© 2024 Princeton Tec

EOS

®

II

(ANSI FL-1 Standard)

Runtime is defined as the duration of time from the initial light output value—defined as 30 seconds after the

point the device is first turned on—using fresh batteries, until the light output reaches 10% of the initial value.

Reserve time is the duration of time from 10% of initial light output value down to 0.25 lux

(Norme ANSI FL-1)

La durée de fonctionnement est la période de temps calculée à partir du rendement lumineux de départ, fixé à

30 secondes après l’activation de l’appareil, avec une batterie neuve, jusqu’à ce que le rendement lumineux

n’atteigne plus que 10 % de sa valeur de départ.

La durée de réserve est la période de temps calculée à partir de 10 % du rendement lumineux de départ

jusqu’à la valeur de 0,25 lux.

(Norme ANSI FL-1)

Leuchtzeit ist definiert als die Zeitdauer von der ursprünglichen Leuchtstärke — definiert als 30 Sekunden nach

dem erstem Einschalten der Leuchte — unter Verwendung neuer Batterien, bis zu dem Zeitpunkt, an dem die

Leuchtstärke 10 % ihrer Anfangsleistung erreicht.

Reservezeit ist die Zeit von 10 % der ursprünglichen Leuchtstärke bis auf einen Wert von 0,25 lx.

ModesLumensRuntimeBeam PatternReserve

HIGHPress 1x =1704h

76h

LOWPress 2x =15100h8h

DISTANCE (m) 0 23 65

Product specificaties