PowerWalker VI 1500 CSW Handleiding

PowerWalker UPS VI 1500 CSW

Bekijk gratis de handleiding van PowerWalker VI 1500 CSW (4 pagina’s), behorend tot de categorie UPS. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 3.8 sterren uit 2.5 reviews. Heb je een vraag over PowerWalker VI 1500 CSW of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Pagina 1/4
ENGLISH
PowerWalker VI 600 1500 CSW-
Quick Guide
I. Overview:
1. LCD display
2. Up/down buon
3. Mute buon
4. ON / OFF buon
5. USB charging port
(5V / 2.1A shared
between 2 ports)
6. USB Communicaon
port with HID support
7. Surge protected -
outlets (no baery
backup)
8. Baery backup with
surge protected
outlets
9. RJ-45 surge protecon
(i.e. for Internet)
10. AC input
11. Venlaon and fan.
12. Circuit breaker (for
French and Schuko)
Surge protected outlets offer EMI ltering, line condioning and surge protecon, -
but they are not supported with backup power from battery in case of AC failure.
II. Operaon
Buon
Funcon
ON/OFF
buon
Press and hold the On/O Buon for 2 seconds and then release to
change state between Standby (output is o) and Line (output is on).
Mute buon
Press and hold the Mute buon for 1 second and then release to
mute or unmute the alarm.
Up/down
buon
Click to switch displayed informaon.
ENGLISH
III. Display
State
Display
Meaning
LED
Alarm
Line /
Standby /
Baery
mode
Input voltage, input frequency, baery voltage, baery
Power, Backup me, output voltage, output frequency,
load Power and load percentage.
k: kilo, W: wa, V: voltage, A: ampere, %: percent, degC:
centigrade degree, Hz: frequency, min: minute
Line
Mode
The UPS is connected to AC input.
AVR
Mode
ashing
When the icon is ashing, the UPS is regulang the
voltage (reducing or increasing the voltage).
Baery
Mode
The UPS is running on battery
every
10 s
All Modes
The UPS alarm is disabled.
All Modes
Baery level in ranges 0 24%, 25 49%, 50 74%, and 75- - - -
100%.
Baery
Mode
Low Battery
every
0.5s
every
1s
All Modes
Load level in ranges 0-24%, 25-49%, 50-74% and 75-100%.
All Modes
Indicates overload.
every
0.5s
every
0.5s
All Modes
Baery replacement needed or the baery is not
connected
Conn
uous
every
2s
Fault
Fault code (here: E14). Check troubleshoong for details.
Connu
ous
Warning
Baery voltage is too high (i.e. wrong baery inserted)
every
1.5s
ENGLISH
IV. Baery Replacement
1. Turn o the connected equipment and unplug it
from the UPS
2. Turn o the UPS and unplug the input cable.
3. Remove two screws located on the boom of the
UPS and slide the baery cover downward, then
outward.
4. Disconnect the baery connector.
5. Slide out the exisng baery pack from the UPS
by grasping the baery pull tap.
Cauon - Do not short the posive wire and negave wire
of baery.
Cauon - DO NOT pull the baery pack out by pulling on
the baery wires.
6. Slide the new baery pack into the UPS.
7. Verify proper polarity. Re connect the baery -
connectors together.
8. Reinstall the battery cover onto the UPS. Now,
the UPS is ready for normal operaon
9. Properly dispose of the old baeries at an
appropriate recycling facility or return them to
the supplier in the packing material for the new
baeries.
Please read all of the WARNINGS and CAUTIONS in the General Manual before
replacing the baeries.
V. Troubleshoong
Fault
Event
E12
Baery mode output high (internal fault)
E14
Output short (check the loads)
E15
Output over current (too much load)
E20
Fan lock fault
E21
Over Charge Voltage (i.e. wrong baery used)
E28
Low baery voltage
E43
Overload fault
Please check hps://troubleshoot.powerwalker.com for more details.


Product specificaties

Merk: PowerWalker
Categorie: UPS
Model: VI 1500 CSW
Kleur van het product: Zwart
Gewicht: 13100 g
Breedte: 99 mm
Diepte: 410 mm
Hoogte: 280 mm
Geluidsniveau: 45 dB
Gewicht verpakking: 13100 g
Breedte verpakking: 188 mm
Diepte verpakking: 500 mm
Hoogte verpakking: 387 mm
Gebruikershandleiding: Ja
LED-indicatoren: Ja
Vormfactor: Tower
USB-poort: Ja
Meegeleverde kabels: USB-kabel
Accu/Batterij voltage: 12 V
Aantal USB 2.0-poorten: 2
Aantal Ethernet LAN (RJ-45)-poorten: 2
Ondersteund aantal accu's/batterijen: 2
Responstijd: 6 ms
Uitgangsvermogen: 900 W
Batterij capaciteit: 9 Ah
Accu/Batterij oplaadtijd: 8 uur
Stroomspanning bescherming: Overcharge, Overload
Frequentie: 50/60 Hz
Power factor: 0.6
Stekker: C14 stekker
Producten per pallet: 60 stuk(s)
Bedrijfstemperatuur (T-T): 0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V): 0 - 90 procent
Type beeldscherm: LCD
Aantal AC uitgangen: 8 AC-uitgang(en)
Stopcontacttypes: C13 stekker
Output power capacity: 1.5 kVA
Ingang operation voltage (min): 170 V
Ingang operation voltage (max): 280 V
Uitgang operation voltage (min): - V
Uitgang operation voltage (max): 230 V
UPS-topologie: Line-interactive
Typische backup tijd op halve lading: 10 min
Typische backup tijd op volledige lading: 3.45 min
Uitgangsspanningsregeling: 10 procent
Golfvorm: Zuivere sinus
Automatic Voltage Regulation (AVR): Ja
USB-poorttype: USB Type-A

Heb je hulp nodig?

Als je hulp nodig hebt met PowerWalker VI 1500 CSW stel dan hieronder een vraag en andere gebruikers zullen je antwoorden