Philips HD7892 - SENSEO Switch Pad Koffiezet apparaat Handleiding

Philips Koffiezet apparaat HD7892 - SENSEO Switch Pad Koffiezet apparaat

Lees hieronder de 📖 handleiding in het Nederlandse voor Philips HD7892 - SENSEO Switch Pad Koffiezet apparaat (16 pagina's) in de categorie Koffiezet apparaat. Deze handleiding was nuttig voor 32 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16

4222.200.0409.1 (4/2016)

HD7892

102

>75% recycled paper

>75% papier recyclé

English

Introduction

Congratulations on your purchase and welcome to Philips! To fully benefit

from the support that Philips offers, register your product at

www.philips.com/welcome.

Clean cold water

Use clean cold water every day. If you have not used the coffee machine for

one day, you have to flush it with clean cold water before you use it again.

To flush the machine, fill the water reservoir with clean cold water, place a

bowl (with a capacity of at least 1500 ml) or 2 cups under the coffee spout

and press the 2-cup button a few times to brew hot water until the water

reservoir is empty.

Fresh filter coffee

To brew a jug of delicious coffee use good-quality pre-ground coffee .

Always use a paper filter size 102.

You can brew up to 7 cups of coffee in the jug.

Fresh coffee pods

Use good-quality fresh coffee pods in this machine for a full, round taste. To

keep the pods fresh longer, store them in a storage container.

Important

Read this user manual carefully before you use the machine and save it for

future reference.

Danger

- Never immerse the machine in water or any

other liquid.

Warning

- Connect the machine to an earthed wall

socket.

- Check if the voltage indicated on the bottom

of the machine corresponds to the local

mains voltage before you connect the

machine.

- This machine can be used by children aged

from 8 years and above and persons with

reduced physical, sensory or mental

capabilities or lack of experience and

knowledge if they have been given

supervision or instruction concerning use of

the machine in a safe way and understand

the hazards involved. Children shall not play

with the machine. Cleaning and user

maintenance shall not be made by children

unless they are 8 years and above and

supervised.

- Keep the machine and its cord out of the

reach of children aged less than 8 years.

- Do not use the machine if the plug, the mains

cord or the machine itself is damaged.

- If the mains cord is damaged, you must have

it replaced by Philips, a service center

authorized by Philips or similarly qualified

persons in order to avoid a hazard.

Caution

- Always return the machine to a service centre

authorised by Philips for examination or

repair. Do not attempt to repair the machine

yourself, otherwise your guarantee becomes

invalid.

- After unpacking the machine, never put the

machine on its side. Always keep it in upright

position, also during transport.

- Never put normal ground coffee or use torn

pods in the pod holders of this machine, as

this causes the pod holders to become

blocked.

- Do not use the machine in combination with

a transformer, as this could cause hazardous

situations.

- Always put the machine on a flat and stable

surface.

- Do not place the machine on a hotplate,

directly next to a hot oven, heater or similar

source of heat.

- Descale the machine at least every 3 months.

Not doing so may cause the machine to stop

working properly. In this case, repair is not

covered under your guarantee.

- Do not use the machine at altitudes higher

than 2200 metres above sea level.

- Do not use the machine at a temperature

below 0°C. Water left in the machine may

freeze and cause damage.

- Never pour any other liquid than clean cold

water into the water reservoir.

- Never flush the machine or let it brew coffee

when the spout is not in place.

- Flush the coffee machine with fresh water

before you use it for the first time (see

chapter ‘First use’). This causes the system to

fill with water, which is essential for the

machine to work properly.

- Never interrupt the descaling process.

- Never use a descaling agent based on

mineral acids such as sulphuric acid,

hydrochloric acid, sulphamic acid and acetic

acid (e.g. vinegar). These descaling agents

may damage the machine.

- The machine is intended for normal

household use only. It is not intended for use

in environments such as staff kitchens of

shops, offices, farms or other work

environments. Nor is it intended to be used

by clients in hotels, motels, bed and

breakfast and other residential environments.

- Do not disassemble the insulated jug.

- Never immerse the insulated jug in water or

any other liquid, as this could cause water to

enter between the walls of the jug.

- The insulated jug is not dishwasher-proof.

- When the jug is filled with coffee, keep it in

upright position to prevent leakage.

- During brewing and until the light stops

blinking, the filter holder is filled with hot

coffee.

General description

1 1-cup pod holder

2 2-cup pod holder

3 Distribution disk

4 Collector ring

5 Drip tray

6 CALC light

7 Jug button

8 2-cup button

9 1-cup button

10 Water reservoir lid

11 Water reservoir

12 Filter holder lid

13 Filter holder

14 Insulated jug lid

15 Insulated jug

16 Measuring spoon

Electromagnetic fields

This Philips machine complies with all applicable standards and regulations

regarding exposure to electromagnetic fields.

First use

The machine starts an automatic flushing cycle when you switch it on for

the first time, no matter which button you press.

1 Put the plug in an earthed wall socket.

2 Remove the water reservoir from the machine and remove the lid from

the water reservoir (Fig. 2).

3 Clean the water reservoir thoroughly in hot water, if necessary with some

washing-up liquid.

4 Fill the water reservoir with clean cold water up to the MAX indication

(Fig. 3).

5 Put the lid back onto the water reservoir and put the water reservoir back

onto the machine (Fig. 4).

6 Place the 1-cup pod holder in the coffee machine. Close the lid and

make sure it is properly locked (Fig. 5).

7 Remove the drip tray from the platform and put a bowl (with a capacity

of at least 1 liter) or the jug under the coffee outflow (Fig. 6).

8 Press one of the buttons on the control panel. All three lights start

flashing (Fig. 7).

9 The flushing cycle starts. During the flushing cycle the system fills itself

with water from the water reservoir. The machine produces more noise

than during a regular brewing cycle.

10 The machine switches off when the water tank is empty (Fig. 8).

11 After the first flushing cycle, clean the collector ring and the pod holder

with hot water and some washing-up liquid or in the dishwasher. Rinse

the insulated jug under the tap.

Brewing a jug of drip-filter coffee

1 Open the lid of the machine (Fig. 9).

2 Remove the pod holder, if present (Fig. 10).

3 Remove the drip tray, if present.

4 Fill the water reservoir with clean cold water up to the level required for

the number of cups of coffee you wish to brew and put the water

reservoir back onto the machine (Fig. 11).

5 Rinse the insulated jug with hot tap water to preheat it .

Tip: To obtain the tastiest and hottest coffee, brew at least half a jug of

coffee.

6 Place the filter holder on top of the insulated jug (Fig. 12).

7 Open the lid of the filter holder.

8 Put a paper filter size 102 in the filter holder. Make sure that you fold the

sealed edges to ensure that the paper filter stays upright during brewing

(Fig. 13).

9 Use the measuring spoon to put the required amount of pre-ground

coffee in the filter (Fig. 14).

Tip: Use one measuring spoon of pre-ground coffee for each cup. Use a

heaped measuring spoon for strong coffee and a level measuring spoon

for mild coffee.

10 Close the lid of the filter holder.

11 Slide the insulated jug on the platform of the machine (Fig. 15).

12 Press the jug button to start the brewing process (Fig. 16).

-The light in the jug button starts flashing and the brewing process

starts. (Fig. 17)

-When all the water from the water reservoir has passed through the

filter, the light in the jug button goes out and the machine switches

off automatically.

13 You can now remove the insulated jug from the machine (Fig. 18).

14 Remove the filter holder from the insulated jug (Fig. 19).

Tip: You can place the filter holder on the drip tray to prevent coffee

from leaking onto your worktop while you pour out coffee from the jug

(Fig. 20).

15 Place the jug lid on the insulated jug and turn it to the keep-warm

position (closed lock symbol) (Fig. 21).

16 Push the lever of the jug lid to pour coffee into one or more cups, (Fig.

22)

Brewing pod coffee

Brewing one cup of pod coffee

1 Fill the water reservoir with clean cold water up to the MAX indication

and put it back onto the machine (Fig. 3).

Note: The MIN indication on the water reservoir indicates the minimum

amount of water required for brewing pod coffee. Always fill the water

reservoir beyond the MIN level.

2 Put the plug in an earthed wall socket.

3 Open the lid of the machine by moving the lever upwards (Fig. 9).

4 Place the drip tray on the platform of the machine (Fig. 23).

5 Place one pod in the 1-cup pod holder with the convex side pointing

downwards (Fig. 24).

Note: Make sure that the pod holder is clean and the sieve in the center

is not clogged, e.g. with loose coffee grounds.

Note: Make sure that the coffee in the pod is distributed evenly and

press the pod lightly into the pod holder.

6 Place the 1-cup pod holder in the machine and close the lid (Fig. 5).

7 Place a cup on the drip tray (Fig. 25).

8 Press the 1-cup button to brew coffee. (Fig. 26)

-The button starts flashing and the machine starts heating up (Fig. 27).

-When the heating-up process is finished, the machine starts brewing

coffee (Fig. 28). After brewing, the machine switches off

automatically.

9 Remove the coffee pod after use by lifting the pod holder out of the

machine and emptying it (Fig. 10).

Caution: Be careful when you do this, for there may still be some hot

water/coffee on the coffee pod(s).

Caution: Never put normal ground coffee or use torn pods in the machine,

as this causes it to become blocked.

Brewing two cups of pod coffee

1 To brew two cups of pod coffee,place the deeper 2-cup pod holder in

the machine. Place two pods in the 2-cup pod holder (Fig. 29).

2 Press the 2-cup button to brew coffee (Fig. 30).

-The button starts flashing and the machine starts heating up (Fig. 31).

-When the heating-up process is finished, the machine starts brewing

coffee (Fig. 32). After brewing, the machine switches off

automatically.

3 Remove the coffee pods after use by lifting the pod holder out of the

machine and emptying it (Fig. 33).

Note: Instead of two pods, you can also place a cappuccino pod, a hot

chocolate pod or a special pod for a mug of strong coffee in the 2-cup pod

holder and place a mug under the coffee spout. In this case, press the 1-cup

button instead of the 2-cup button to brew your beverage.

Product specificaties

Merk:	Philips
Categorie:	Koffiezet apparaat
Model:	HD7892 - SENSEO Switch Pad Koffiezet apparaat

Heb je hulp nodig?

Als je hulp nodig hebt met Philips HD7892 - SENSEO Switch Pad Koffiezet apparaat stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag