Hardware Resources UBPO-5SC Handleiding

Bekijk gratis de handleiding van Hardware Resources UBPO-5SC (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.4 sterren uit 5 reviews. Heb je een vraag over Hardware Resources UBPO-5SC of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Bottom Measurements

NOTE: Illustrations for measurement only.

1.25”

2.5”

14.6”

2”

Rear Bracket Measurements

1-3/16”

11/32”

15/16”

1-3/4”

1-5/32”

IMPORTANT:

Before you begin, make sure you familiarize yourself with all the

parts and fully read the instructions.

CUSTOMER SERVICE:

Toll-free customer help line available weekdays between

7:00am and 6:00pm Central Time at 800-463-0660.

TOOLS NECESSARY:

Screw gun or Phillips screwdriver and tape measure. NOTE: If

screw gun has a clutch, set to lowest setting so as not to over

tighten and/or strip screws.

PARTS IDENTIFICATION:

AMounting Base1 pcs

BBase Pullout Unit1 pcs

C4” x 6” Stainless Steel Canister4 pcs

D#10 x 3/4” Pan Head Wood Screw4 pcs

E#8 x 5/8” Pan Head Wood Screw4 pcs

F#8 x 5/8” Flat Head Wood Screw4 pcs

Utensil Bin Base Pullout

Installation Instructions

for the UBPO Series

A

E

D

F

C

B

Scan to watch the installation video

http://delivr.com/265Z6

20-7/8”

Bottom of cabinet

STEP 1 - Install Base

Front plywood runner

Pull out

Face frame

Front plywood

runner

Remove the base from the unit by releasing the slide clips. In

framed cabinets, center the unit in the opening making sure

the front plywood runner is pulled tight against the back of

the face frame. For frameless cabinets, place the unit within

1-1/2” of the left of the cabinet and the front plywood runner

needs to be set back 3/4”. Install with the four (4) #10 x 3/4” Pan

Head Wood Screws provided in the four pre-drilled holes in the

runners. Re-install the unit onto the slides.

Product specificaties