CRUX SWRFD-60L Handleiding

Bekijk gratis de handleiding van CRUX SWRFD-60L (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 77 mensen en kreeg gemiddeld 4.2 sterren uit 8 reviews. Heb je een vraag over CRUX SWRFD-60L of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.020620

SWRFD-60L

Radio Replacement with SWC + Aux Input Retention

for FORD, LINCOLN & MERCURY Vehicles

1 of 3

RADIO REPLACEMENT

SWC RETENTION

+

R

INTERFACING SOLUTIONS

- Retains factory features in select FORD, LINCOLN, and MERCURY vehicles while functioning with an

aftermarket radio.

- Pre-programmed to retain factory Steering Wheel Controls.

- iPhone Voice Recognition (VR) feature from SWC on select Kenwood, Pioneer, Alpine and JVC radios.

- Retains factory Aux-Input and Subwoofer (if equipped).

- EIA color coded wiring for easy installation.

PRODUCT FEATURES:

PARTS INCLUDED:

INSTALLATION DIAGRAM:

SWRFD-60L MODULESWRFD-60L HARNESSAntenna AdapterSWC CABLE

AFTERMARKET

RADIO

+12V Constant Yellow

+12V ACC Red

12V Ground Black

Illumination Orange

Vehicle Speed Sense Red/White

(or Brown)

Subwoofer Amp Turn-on Blue/White

Antenna Turn-on Blue

Right Front (+) Gray

Right Front (-) Gray/Black

Left Front (+) White

Left Front (-) White/Black

Right Rear (+) Violet

Right Rear (-) Violet/Black

Left Rear (+) Green

Left Rear (-) Green/Black

Subwoofer

Factory Aux Input

24-Pin

Plug*

16-Pin

Plug*

8-Pin

Plug*

TO FACTORY

HARNESS

12-Pin

Connector

SWC TYPE

(Connect PINK to PINK wire)

Subwoofer

Converter

Module

*Inspect that the male pins are

properly lined up before plugging

into the factory harness.

SWRFD-60L

MODULE

ON RADIOVEHICLE

1 2 3 4 5 6 7 8

AFTERMARKET

RADIO SELECTOR

(See Chart)

FORD

SWC SETTING

(OFF OFF OFF OFF)

ON RADIOVEHICLE

1 2 3 4 5 6 7 8

Cap or insulate if

not being used

Kenwood/JVC (BLUE / YELLOW)Insulate with tape

if not being used

3.5MM SWC CABLE

Plug in the 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

Blue/Yellow

(Not Used)

Product specificaties