CRUX SWRNS-63F Handleiding

Bekijk gratis de handleiding van CRUX SWRNS-63F (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 76 mensen en kreeg gemiddeld 4.2 sterren uit 6 reviews. Heb je een vraag over CRUX SWRNS-63F of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Crux Interfacing Solutions • Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.230122

SWRN S-63F

Radio Replacement with Steering Wheel Control Retention

1 of 2

RADIOEPLANT RCE ME

SWRETTIO NC EN

+

R

INTERFACING SOLUTIONS

- Pre-programmed to retain factory Medium Speed CAN-Data Bus Steering Wheel Controls.

- Includes antenna adapter.

PRODUCT FEATURES:

PARTS INCLUDED:

SWRNS-63F HarnessAntenna

AdapterSWRNS-63F MODULESWC CablesUSB Retention Cable

- Retains Bose Amplier.

- Retains factory USB & Auxiliary input .

- Retains factory camera (not 360 panoramic camera)

- Provides outputs for parking brake and reverse gear.

for Select NISSAN SENTRA Vehicles 2019 and Up with out CarPlay

INSTALLATION DIAGRAM FOR NON-AMPLIFIED VEHICLES:

AFTERMARKET

RADIO

+12V Constant Yellow

+12V ACC Red

Ground Black

Illumination (+)Orange

Illumination (-)Orange/White

Amp Turn On Blue/ White

Right Front (+) Gray

Right Front (-) Gray/Black

Left Front (+) White

Left Front (-) White/Black

Right Rear (+) Violet

Right Rear (-) Violet/Black

Left Rear (+) Green

Left Rear (-) Green/Black

VSS (Vehicle Speed Signal)Brown/White

Chassis Ground Black

Reverse Gear OutputViolet/White

**Ignition power OutputRed/Black

(with Ring Terminal)

TO FACTORY

HARNESS

12-Pin Black

Connector

BLUE/ Power Antenna

4-Pin

Connector

Yellow RCA

(Retain OE Camera)

Rear View Camera Signal

Option A:

Option B:

Cap or insulate if

not being used

BLUE / YELLOW

Insulate with tape

if not being used

3.5MM SWC CABLES (Option A or B)

Use the proper 3.5MM to 4-Pin cable for your radio.

Plug in the selected 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

To aftermarket

radio SWC wire

or 3.5mm port

1 2 3

ON

USB-Min2

USB Retention Adaptor(included in kit)

12v to 6v

Converter

Audio Input Red/White RCA

(Retains Factory AUX Input)

*

*

*

*

*

*

*

*

** ACC Power Output Note: For vehicles equipped with intellegent key systems (Push Start Button)

+12 V accessory red wire may not activate radio, must use ignition power output (Red/Black wire) instead.

40 PIN

20 PIN

Product specificaties