CRUX SWRHK-65P Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor CRUX SWRHK-65P (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.062419
SWRHK-65P
Radio Replacement with Steering Wheel Retention for
HYUNDAI and KIA Vehicles with 24 Pin Connector
1 of 2
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Hyundai and Kia vehicles while functioning with an aftermarket radio.
- Retains factory 3.5mm Aux Input Jack (if equipped).
- Pre-programmed to retain factory Steering Wheel Controls.
- Includes Hyundai/Kia antenna adapter.
- EIA color coded wiring for easy installation.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRHK-65P MODULE SWRHK-65P HARNESS ANTENNA ADAPTER SWC CABLE
24-PIN
Connector
AFTERMARKET
RADIO
SWC
MODULE
illumination (+) Orange
Vehicle Speed Sensor Red/White
Antenna Turn ON Blue
+12V Constant Yellow
+12V ACC Red
Ground Black
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Audio Signal from 3.5mm Jack Aux-In Red & White RCA
TO FACTORY
HARNESS
12-Pin Black
Connector
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS section.
Note:
Output signal(s) stated above may not cover all Year/Model.
HYUNDAI/KIA ANTENNA
ADAPTOR (Included)
AFTERMARKET
RADIO SELECTOR
(See Chart)
HYUNDAI / KIA TYPE
SWC SETTING
(OFF OFF ON ON)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
4-Pin
Connector
Insulate with tape
if not used
Kenwood / JVC
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.062419
2 of 2
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
VEHICLE APPLICATIONS:
SWRHK-65P
DIP SWITCH SETTINGS:
HYUNDAI / KIA STEERING WHEEL CONTROL DIP SWITCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
Hyundai
2006 - 2009 Accent
2006 - 2008 Azera
2009 - 2011 Azera (with NAV Radio + AMPs)
2007 - 2008 Elantra
2007 - 2008 Entourage
2009 - 2009 Genesis
2008 - 2009 Santa Fe (with NAV Radio + AMPs)
2009 - 2010 Sonata
2007 - 2008 Veracruz
2009 - 2010 Veracruz (with NAV Radio + AMPs)
Kia
2006 - 2008 Aman*
2006 - 2008 Opma
2007 - 2008 Rondo
2006 - 2008 Sedona*
2007 - 2009 Spectra
2009 - 2010 Sportage
*Not equipped with Seek Up/Dn on SWC
DIP: 5 6 7 8
Hyundai / Kia OFF OFF ON ON
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
RADIO BRAND: DIP: 1 2 3 4
Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most o-brand Radios
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE: For Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios,
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable and set the DIP switches to the aermarket radio you are using. Use the
Blue/Yellow wire for Kenwood and JVC radios and the 3.5mm plug for other radios.
NOTE: Insulate the Blue/Yellow wire or 3.5mm plug if not being used.


Product specificaties

Merk: CRUX
Categorie: Niet gecategoriseerd
Model: SWRHK-65P

Heb je hulp nodig?

Als je hulp nodig hebt met CRUX SWRHK-65P stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd CRUX

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd