Vimar 01978 Handleiding

Pagina's 1 Niet gecategoriseerd

Bekijk de handleiding van Vimar 01978 gratis online of download de PDF. Deze handleiding is 0 keer bekeken. Vraag over dit model? Stel een vraag

PDF downloaden (0.2 MB) Specificaties

Viale Vicenza, 14 - I 36063 Marostica VI

Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709

www.vimar.eu

Instruction sheet

49400435A0 01 1111

VIMAR - Marostica - Italy

01978

Actuator with output PWM 150 mA for driver LED control,

relay output 12-24 V 10 A, power supply 12-24 V~ 50-60 Hz,

or 12-24 V d.c., installation on DIN rail (60715 TH35), occupies

3 modules of 17.5 mm. Version for MARINE applications.

Actuator for driver LED with PWM control. The device is controlled by a rocker

push-buttons. The device’s maximum output current is 150 mA.

CHARACTERISTICS.

•Ratedsupplyvoltage:BUS29V

•Input:10mA

•Auxiliarysupply:12-24V~±10%or12-24Vd.c.±10%(SELV)

•Consumption:

-12V~:700mA12Vd.c.:300mA

-24V~:700mA24Vd.c.:250mA

•Dissipatedpower:3.5W

•DistancebetweenactuatorandLEDdriver:10mmaxwithtwistedcable

•Terminals:

-TPBUS

-12-24V~50-60Hz,12-24Vd.c.

-relaycontacts(NO,C)

- control PWM

•NOrelayoutput

•Controllableloadsat12-24V~or12-24Vd.c:

-resistiveloads:10A(20.000cycles)

-LEDspotlights:10A(20.000cycles)

•Operatingtemperature:-5°C-+45°C(forindooruse)

•3modulesof17.5mm.

CONNECTIONS.

Thewirediagram(bottomright)showsanexampleofaconnectionanLEDdriver.

DependingonthetypeofLEDdriverused,theconnectionofterminal+ to the LED

driverthroughtherelaycontactsintegratedindevice01978maynotbenecessary;

inthiscase,connectterminal+directly to the electric phase.

Thefeedingcircuitoftherelayoutputmustbeprotectedagainstoverloadsbya

fusewithratedcurrentnothigherthan12A.

CONFIGURATION.

FOR THE DETAILS OF INSTALLATION AND CONFIGURATION, SEE THE

By-me SYSTEM INSTRUCTIONS MANUAL ATTACHED TO THE CONTROL

UNIT.

•Functionalblocks:1;theblockcanbelongtoatmost4groups.

•Selectingthefunctionalblock(configuration),whenthecontrolunit,duringgroup

creation,requirespressingthedevicebutton:

-presstheconfigurationbutton,theredLEDwilllightup;

-withtheredLEDon,thecontrolunitwillconfigurethefunctionalblock;attheend

ofthisoperationtheredLEDwillgoout.

PARAMETERS.

•Adjustmentspeed:low,mediumorhigh.

•LEDalwaysofforononlywithdimmeron.

•Parameteroffset:minimumoutputvoltage.

•Defaultparameters:dimmeractuatorwithmediumadjustmentspeed,LED

alwaysoffandoffsetofminimumoutputvoltage.

SCENARIOS.

Theactuatorcanbelongtoupto4differentscenariosand,foreachscenario,save

thestatustoretrievewhenactivatingthescenario.

INSTALLATION RULES.

Installationshouldbecarriedoutincompliancewiththecurrentregulationsregarding

the installation of electrical systems in the country where the products are installed.

Forfurtherinstructions,pleaserefertothemanualenclosedwiththecontrolpanel.

CONFORMITY TO STANDARDS.

EMCdirective

StandardsEN50428,EN50491.

Foruse,thisdevicehasbeensubmittedtothefollowingtests:MARINE

IEC60068-2-52-TestKb:Saltmist,cyclic(sodium,chloridesolution),

IEC60068-2-6-TestFc:Vibration(sinusoidal)

This device complies with part 15 of the FCCRules(withthelimitsforaClassB

digitaldevice).Operationissubjecttothefollowingtwoconditions:

(1)Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptany

interferencereceived,includinginterferencethatmaycauseundesiderableoperation.

ACTUATOR PWM

1012-24VA

01978

12-24V

1012-24VA

BUS PWM 150mA

By-me

CONF.

FRONT VIEW AND CONNECTIONS.

ConfigurationLed.

Configurationbutton.

BUSline

Connectionto

the LED

driver

12-24V~

12-24Vdc

LED

Driver

bus line

ACTUAR PWMTO

10A 12-24V

01978

12-24V

10A 12-24V

BUS PWM 150mA

By-me

CONF.

FUSE

12-24 V

LED

Driver

LED

Driver

EXAMPLE OF CONNECTION.

Beoordeel deze handleiding

Product specificaties

Merk:	Vimar
Categorie:	Niet gecategoriseerd
Model:	01978

Heb je hulp nodig?

Als je hulp nodig hebt met Vimar 01978 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Vimar 01978 Handleiding

Product specificaties

Heb je hulp nodig?

Meer handleidingen van Vimar

Andere merken