Tripp Lite SmartPro SMC1500T Handleiding

Tripp Lite UPS SmartPro SMC1500T

Lees hieronder de 📖 handleiding in het Nederlandse voor Tripp Lite SmartPro SMC1500T (32 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32

Owner’s Manual

SmartPro® SMC Tower

Intelligent, Line-Interactive UPS Systems

100/110/120V Input/Output • Sine Wave Output

Models: SMC1000T, SMC1500T

(Series No. AGSM5384, AGSM7136)

Not suitable for mobile applications.

Important Safety Instructions 2

Quick Installation 3

Optional Installation 4

Basic Operation 4

Battery Replacement 8

Storage & Service 9

Product Registration 10

Regulatory Compliance 10

Español 11

Français 21

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com

® is a registered trademark of Tripp Lite.

PROTECT YOUR INVESTMENT!

and ultimate peace of mind.

You could also win an

ISOBAR6ULTRA surge protector—

a $50 value!

www.tripplite.com/warranty

14-12-046-93338B.indb 1 12/23/2014 10:21:52 AM

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be followed during the

installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed

these warnings may affect your warranty.

UPS Location Warnings

• Install your UPS indoors, away from excess moisture or heat, conductive

contaminants, dust or direct sunlight.

• For best performance, keep the indoor temperature between between 32º F and

104º F (0º C and 40º C).

• Leave adequate space around all sides of the UPS for proper ventilation.

• Do not mount unit with its front or rear panel facing down (at any angle).

Mounting in this manner will seriously inhibit the unit’s internal cooling,

eventually causing product damage not covered under warranty.

UPS Connection Warnings

• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the

UPS into itself; this will damage the UPS.

• Be sure to use the proper overcurrent protection for the installation, in accordance

with the plug/equipment rating.

• Do not modify the UPS's plug, and do not use an adapter that would eliminate the

UPS’s ground connection.

• Do not use extension cords to connect the UPS to an AC outlet.

• The electrical outlets supplying power to the equipment should be installed near the

equipment and easily accessible.

• If the UPS receives power from a motor-powered AC generator, the generator must

provide clean, filtered, computer-grade output.

Equipment Connection Warnings

• Use of this equipment in life support applications where failure of this equipment can

reasonably be expected to cause the failure of the life support equipment or to

significantly affect its safety or effectiveness is not recommended. Do not use this

equipment in the presence of a flammable anesthetic mixture with air, oxygen or

nitrous oxide.

• Do not connect surge suppressors or extension cords to the output of your UPS.

This might damage the UPS and will void the surge suppressor and UPS warranties.

Battery Warnings

• Batteries can present a risk of electrical shock and burn from high short-circuit

current. Observe proper precautions. There are no user-serviceable parts inside the

UPS. Do not open the UPS except to perform battery replacement. Do not open

batteries. Do not short or bridge the battery terminals with any object. Unplug and

turn off the UPS before performing battery replacement. Use tools with insulated

handles. Battery replacement should be performed only by authorized service

personnel using the same number and type of batteries (Sealed Lead-Acid). Do not

dispose of the batteries in a fire. The batteries are recyclable. Refer to your local

codes for disposal requirements.

Important Safety Instructions

14-12-046-93338B.indb 2 12/23/2014 10:21:52 AM

1 With the UPS disconnected from utility

power, use a small tool to set the

Voltage DIP Switch to match your

input voltage. (All models are preset

to the 120V setting.)

2 Plug the UPS into an outlet on a

dedicated circuit.

NOTE! after you plug the UPS into a live AC

outlet, the UPS will automatically charge its

batteries,* but will not supply power to its

outlets until it is turned ON.

* The BATTERY CHARGE LED will be the only LED

illuminated

3 Plug your equipment into the UPS.

Model SMC1500T: All outlets provide battery

backup and surge protection for computers,

monitors and other critical devices. Model

SMC1000T: Select outlets provide battery

backup and surge protection for computers,

monitors and other critical devices; select

outlets provide surge protection only for

printers and other nonessential devices.

Do not plug high-draw equipment such as

laser printers into the battery backup/

surge protection outlets.

Note: Your UPS is designed to support electronic

equipment only. You will overload the UPS if the total VA

rating for all equipment connected through the battery

backup/surge protection outlets exceeds the UPS's

Output Capacity. To find your equipment's VA ratings, look

on their nameplates. If the equipment is listed in amps,

multiply the number of amps by 120 to determine VA.

(Example: 1 amp × 120 = 120 VA). If you are unsure if

you have overloaded the UPS's outlets, see “OUTPUT

LOAD LEVEL” LED description.

4 Turn the UPS ON.

Press and hold the “STANDBY” button for one

second. The alarm will beep once briefly after

one second has passed. Release the button.

Note: UPS system will function properly upon initial

startup; however, maximum runtime for the unit’s battery

will only be accessible after it has been charged for

24 hours.

Quick Installation

SMC1500T model shown.

14-12-046-93338B.indb 3 12/23/2014 10:21:53 AM

Product specificaties

Merk:	Tripp Lite
Categorie:	UPS
Model:	SmartPro SMC1500T
Kleur van het product:	Zwart
Gewicht:	20410 g
Breedte:	171.4 mm
Diepte:	336.6 mm
Hoogte:	260.4 mm
Gewicht verpakking:	19910 g
Breedte verpakking:	243.8 mm
Diepte verpakking:	464.8 mm
Hoogte verpakking:	355.6 mm
LED-indicatoren:	Ja
Vormfactor:	Tower
USB-poort:	Ja
Land van herkomst:	China
Uitgangsvermogen:	900 W
Frequentie:	- Hz
Seriële poort(en):	1
(Buitenste) hoofdverpakking hoogte:	355.6 mm
(Buitenste) hoofdverpakking breedte:	243.8 mm
(Buitenste) hoofdverpakking brutogewicht:	19910 g
(Buitenste) hoofdverpakking lengte:	464.8 mm
Hoeveelheid per (buitenste) hoofdverpakking:	1 stuk(s)
Aantal AC uitgangen:	8 AC-uitgang(en)
Stopcontacttypes:	NEMA 5–15R
Output power capacity:	1.5 kVA
Ingang operation voltage (min):	95 V
Ingang operation voltage (max):	145 V
Uitgang operation voltage (min):	- V
Uitgang operation voltage (max):	- V
UPS-topologie:	Line-interactive
Typische backup tijd op halve lading:	17.4 min
Typische backup tijd op volledige lading:	6.4 min
Seriële interface:	Ja