Salus MD34S Handleiding


Pagina's 1 Niet gecategoriseerd

Bekijk de handleiding van Salus MD34S gratis online of download de PDF. Deze handleiding is 1 keer bekeken. Vraag over dit model? Stel een vraag

This product complies with the essential requirements and other
relevant provisions of Directives GPSR 2023/988/UE, REACH 251 SVHC
1907/2006. The full text of the EU Declaration of Conformity is available
at the following internet address: www.saluslegal.com.
Product compliance
Introduction
The Magnetic Filter is specially designed for central heating systems.
It can remove almost all the harmful black suspended iron oxide
complete central heating system.
Use the device in accordance with national and EU regulations.
Use the device for its intended purpose. The product is intended
for indoor use only. Installation must be carried out by a qualied
person in accordance with national and EU regulations.
Safety information
SALUS Controls is part of the Computime Group.
In accordance with our policy of continuous product
development, SALUS Controls plc reserves the right to
change the specications, design and materials of the
products listed in this brochure without prior notice.
05/2026
www.saluscontrols.com
DK: Support@salus-controls.dk
Product components
MANUAL
MD34S
IN-LINE MAGNETIC FILTER
WITH ¾" VALVES
QUICK GUIDE
Manufacturer:
SALUS Controls plc
Units 8-10, Northeld Business Park, Forge Way,
Parkgate Rotherham, S60 1SD, United Kingdom
Importer:
Salus Controls European Distribution sp.z o.o.
ul. Szamocka 8, piętro 6., 01 748 Warszawa, Poland
EN
Recommended installation location
RETURN
Boiler
RETURN
Boiler
Pump
Header Tank
FIG1:
Combination/Sealed system
FIG2:
Open vented system
1
234
Installation
1. Cut and remove the section of the pipe according to
the product installation length;
2. Install the valves onto the pipework, hand tighten only at rst,
then tighten securely the valve to the pipe;
3. Install the lter housing and tighten it;
4. Adjust the Angle and secure the lter;
5. Make sure the valves are open, allow the system to ll, open, and
vent the lter through the air vent valve, close when complete.
1. Close both the isolation valves;
2. Open the drain valve, place a bucket or similar receptacle below
ready to collect the debris. Take out the magnetic bar and store in a
safe place;
3. Open the inlet valve to ush out the debris, once all the debris
has been removed introduce a suitable chemical inhibitor into the
system, we recommend Salus LX1 inhibitor, ret the magnetic bar;
4. Open the inlet and outlet valve, vent the lter through the air vent
valve close when complete.Check for any leaks;
5. Complete any relevant documentation.
IE: Dates and inhibitor used.
Maintenance and servicing
In-Line, Magnetic Filter
3/4"
6 bar
95°C
Yes (Salus LX1)
Type
Valve size
Maximum working pressure
Maximum operating temp.
Chemical inhibitor compatibility
Technical specications
1. The magnetic lter contains powerful magnets, please keep
away from all electronic devices, bank cards
and other magnetic devices;
2. The Magnetic Filter contains powerful magnets and should
always be used with caution especially for
devices such as pacemakers;
3. The Magnetic Filter is a pressurized device, pressure must be
released prior to maintenance;
4. The Magnetic Filter device could be very hot during operation.
Please be careful!
* In order to maintain grounding continuity in accordance with the
current IEE regulations, appropriate grounding cables should be
installed on the pipe where necessary to bypass the product.
Note: It is recommended that the magnetic lter is installed and
maintained by a competant and qualied person. Any queries
arising from either installation or servicing, contact SALUS Controls
Please note:
1
1
Air vent valve
2
3
4
5
Magnet bar
Drain valve
Inlet valve
Outlet valve
4
2
5
3

Beoordeel deze handleiding


Product specificaties

Merk: Salus
Categorie: Niet gecategoriseerd
Model: MD34S

Heb je hulp nodig?

Als je hulp nodig hebt met Salus MD34S stel dan hieronder een vraag en andere gebruikers zullen je antwoorden