Monacor PREAMP-1UP Handleiding

Monacor Controller PREAMP-1UP

Bekijk gratis de handleiding van Monacor PREAMP-1UP (2 pagina’s), behorend tot de categorie Controller. Deze gids werd als nuttig beoordeeld door 56 mensen en kreeg gemiddeld 4.3 sterren uit 28.5 reviews. Heb je een vraag over Monacor PREAMP-1UP of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/2

Technical data S.1/2

Preamplifier PREAMP

Technical modifications reserved 07/04

Thank you for buying a WHD product. Please read this manual carefully,especially the ! marked parts.

Content :

PREAMP CD500 uP ... :

Pre-Amplifier with metal front plate. Plastic front plate with printing.Plasic rotary knobs.Accessory subframe

CD500 ,colour : “ alpinweiss “

PREAMP uP ... :

Pre-Amplifier with metal front plate. Plastic front plate with printing.Plasic rotary knobs.

Colour : “ alpinweiss “

The subframes are not available at WHD.

PREAMP BJ uP ... :

Pre-Amplifier with metal front plate. Plastic front plate with printing.Plasic rotary knobs.

Colour : “ alpinweiss “

The subframes are not available at WHD.

Specifications :

Supply voltage : 22-26V

Output voltage : 5V max.

Output impedance : 50 Ω

Input voltage Line : 400 mV

Input voltage Mic : 4mV

Frequency range Line : 20-20 000 Hz (-1dB)

Frequency range Mic : 40-15 000 Hz (-3dB)

Current consumption : 0,025 A

Terminal : 7 -pole terminal , removeable

Control voltage : 0-10VDC

Additional parts : ( JUNG/CD500 frames and UP-cabinets KAISER available at WHD)

Subframe Frame

single Frame

double UP-cabinet

61/63 mm

X X X

The microphone volume control has a combined ON-OFF switch.

Technical data - S. 2/2 - Pre- amplifier PREAMP ...

Technical modifications reserved 07/04

Mounting :Mounting :

Connect terminal according to wiring scheme.

Backside view

Note : The control terminal no. 4 gets a voltage of 12V by an internal resistor. So the preamplifier

has the maximum gain at open terminal.

Terminal no

1 + Signal – out ( unbalanced )

2 0 Signal

3 Reduced gain

4 + Control input 0-12 VDC

5 0 V Control

6 0 Supply voltage

7 + 24V Supply voltage

8 0 V Phantom / Mic

9 + Mic input

10 + 24V Phantom

If the gain is too high for some applications , connect the accessory wire bridge to terminal 3 and 5.

This will reduce the gain to app. 1/3.

Note : Teminal 8 to 10 is only for use with input balance unit.

For the signal and control line we recommend shielded cable.

e.g. LIYCY 0.14mm² 2-cores

The cross section of the power supply cable should be adequate.

e.g. H03VV-F 0,5mm² 2-cores

We recommend regulated 24VDC power supply with short circuit protection.

Product specificaties

Merk:	Monacor
Categorie:	Controller
Model:	PREAMP-1UP
Kleur van het product:	Wit
Soort:	Draaivolumeregelaar
Montagewijze:	Wandmontage
Frequentiebereik:	20 - 20000 Hz
Output impedance:	50 Ohm
Ingang operation voltage (max):	0.4 V
Power handling:	- W