Forte Lighting 5745-02 Handleiding

Bekijk gratis de handleiding van Forte Lighting 5745-02 (1 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 4.1 sterren uit 5 reviews. Heb je een vraag over Forte Lighting 5745-02 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

5745-02 5745-03 5745-04

crossbar.

The crossbar (B) has several pairs of threaded holes. Find the pair of holes that matches the spacings on the junction box and your

fixture’s backplate. Two mounting screws (A) should be attached to the crossbar (B). Pull the house wires through the center of the crossbar (B).

Place the crossbar (B) against the junction box so that the mounting screws (A) are aligned with the holes on the fixture’s backplate (F). Secure

the crossbar (B) to the junction box by securely tightening the mounting screws (G).

Place the fixture’s backplate (F) over mounting screws (G) so that they protrude through the holes on the backplate. Screw deco nuts (A)

onto the junction box. Twist until the backplate of the fixture is snugly against the wall. Install light bulb(s) (not included) in accordance

with the fixture’s specifications. Do not exceed the recommended maximum wattage. Check t numr mark r t Shade Cap (H), hebeundehe

and find t Glass Shade (J) with the same numr it is mark on t She Thrd-Ring (I). Attach the Glass Ses (J) to the Socket hebeheadeahad

by turning clockwise til tight. Secure t other Glass Shunit’s headonhees (J) to t corresponding Socket Thread Rings (H).

B

A

C

J

H

I

These instructions are provided for your safety. It is very important to read them carefully and completely before beginning

installation of the lighting fixture.We strongly suggest that all direct-wired fixture be installed by a qualified and licensed

electrician.

W A R N I N G! S H U T POWER OFF AT FUSE OR CIRCUIT BREAKER

BEFORE INSTALLATION

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DIS JONCTEUR.

Attach the fixture’s wires to the power supply wires from the junction box. Connect the black wire with the black( or smooth); the white wrie with

the white (or ribbed); the ground wire with the ground (green or copper). Twist the end of the wire pairs together and twist on a wire connector.

Make sure all twists are in the same direction. If there is no ground wire(green or copper) from the junction box, locate a ground screw (C) on the

crossbar (B) and wrap the fixture’s the ground wire around the green ground screw (C). Use a screwdriver to tighten the ground screw (C) onto the

crossbar. Tuck all wires neatly into the junction box.

CLEANING TIPS

Treat the fixture gently! Regular cleaning will reduce the need of deep cleaning. For regular cleaning, turn off the lighting and wipe down

the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.

Product specificaties