EtherWAN EX17008A Handleiding

Bekijk gratis de handleiding van EtherWAN EX17008A (2 pagina’s), behorend tot de categorie Csavaros gép. Deze gids werd als nuttig beoordeeld door 24 mensen en kreeg gemiddeld 4.4 sterren uit 2 reviews. Heb je een vraag over EtherWAN EX17008A of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Copyright 2020 EtherWAN Systems, Inc. Page 1

All Rights Reserved

EX17008A

02/25/2020

W70G-E17008AQ3

1 Unpacking

Unpack the items. Your package should include:

One EX17008A unmanaged switch

One AC power cord

One CD containing this user’s guide

If items are missing or damaged, notify your

EtherWAN representative. Keep the carton and

packing material.

2 What Else You Need

Category 5 or better Ethernet cables

3 Select a Location

Desktop installations: Mount on a flat table

or shelf surface.

Rack installations: Use a 19-inch (48.3-

centimeter) EIA standard equipment rack

that is grounded and physically secure.

Identify a power source within 6 feet (1.8

meters).

Choose a dry area with ambient temperature

between 0 and 40ºC (32 and 104ºF).

Do not cover fans on the rear and side.

Keep away from heat sources, sunlight, warm

air exhausts, hot-air vents, and heaters.

Be sure there is adequate airflow.

Keep the switch at least 6 ft (1.83 m) away

from the nearest source of electromagnetic

noise, such as a photocopy machine.

4 Connect to the Data Ports

The switch is equipped with eight 10/100 Mbps

RJ-45 port that provide IEEE802.3at Power over

Ethernet (PoE), with up to 30 Watts per port (50

- 57VDC, 600mA Max.) These ports can be

connected to PoE devices such as IP surveillance

cameras or Voice Over Internet Protocol (VoIP)

phones.

A.Insert one end of a Category 5 or better

Ethernet cable into a switch port.

B.Connect the other end into the Ethernet port

of the device.

C.Repeat steps A and B for each additional

device you want to connect to the switch.

5 Apply AC Power

A.Connect the female end of the supplied AC

power cord to the power receptacle on the

switch rear panel. Connect the other end to

a grounded 3-pronged AC outlet.

B.On the switch rear panel, move the ON/OFF

switch to the ON position.

When you apply AC power:

All green PoE and Link/ACT LEDs blink

momentarily.

The fans start.

The yellow Power LED goes ON.

The Link/ACT LEDs for every port connected

to a device flash, as the switch conducts a

brief Power On Self-Test (POST).

6 Front Panel LEDs

LED

Color

Status

Power

Yellow

ON = switch is receiving power.

PoE

(port number)

Green

ON = Power Device (PD) is connected.

OFF = PD is disconnected.

Link/ACT

(port number)

Green

ON = valid network connection.

OFF = no data transmission on port.

Flashing = port is sending or receiving

data.

Congratulations! You have successfully

installed your switch.

EX17008A Unmanaged Switch Installation Guide

Product specificaties