Elektrobock PT32 Handleiding

Elektrobock Thermostaat PT32

Lees hieronder de 📖 handleiding in het Nederlandse voor Elektrobock PT32 (16 pagina's) in de categorie Thermostaat. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16

MADE IN CZECH REPUBLIC

• LARGE BACKLIT DISPLAY

with intuitive navigation in CZ/PL/EN/DE/RU/SK

•

9 WEEKLY PROGRAMS

and 6 temperature changes per day

• HYSTERESIS/ PI/PID REGULATION

selection according to the heating system

• ENERGY SAVINGS UP TO 30%

quick investment return

•

OPTIMALISATION OF OPERATION

preliminary switch-on function

Temp. 23

HEATING

TEMPE-

RATURE

CHANGE

17°C

7°C

7°C17°C 23°C

23°C

23°C23°C

SENT

REMOTE CONTROL BY MEANS OF MOBILE PHONE

by extending the thermostat with the GST1 or GST2 module (not included in PT32)

DESCRIPTION

PT32 is an intelligent digital room thermostat with a backlit display. Its advantages involve a quick change

in the desired temperature by simply turning the wheel, and possibility of setting up to 9 weekly programs

with 6 temperature changes per day.

INSTALLATION AND LOCATION

Install the thermostat at a suitable place where its operation cannot be affected by direct ﬂ ow

of hot air from the heater, sunshine or other disturbing effects. Do not install it on an external

wall either. The installation height should be approx. 1.5 m above the ﬂ oor. Place the thermo-

stat in the “reference room”, such as the living room (the heating source will switch according

to the temperature in this room).

The installation must only be done by a properly qualiﬁ ed person!

Before installation, disconnect the power supply!

1) Switch off the main circuit breaker.

2) Remove the control part from the lower cover of the device (Fig.1, page 3).

3) Chip away the central plastic piece from the lower cover to lead in conductors.

4) Run the conductor through the hole and connect it to the terminal acc. to the diagram.

5) Fasten the lower cover to the wiring box with screws (Fig. 2, page 3).

6) Batteries are located at the back of the control part. Remove their protective paper

(on ﬁ rst use), or insert new batteries (follow the instructions on page 3).

7) Mount the control part on the lower cover.

8) Switch on the main circuit breaker and test correct connection of the thermostat, see

page 12 (TEST).

9) Upon ﬁ rst start (or reset), the thermostat displays “SET CLOCK”, set the current time

and date according to page 5. After that select language see page 8.

Backlit display

if any button is pushed, the backlit switches on

automatically for 5 s at least

Control elements

turning

= change of the temperature set

short push

= choice conﬁ rmation (entry)

= quick change of the temperature

or program desired, viewing

the running hours (see page 4)

long push

= step back (only in the CONST

mode see pages 8-13)

push

= opening the main menu or return

a step back

Wiring diagram:

PT32 BOILER

potential-free

(voltage-free) contact

The thermostat

terminals are marked

differently with

every type of boiler.

Therefore, follow the

wiring prescribed by

the boiler

manufacturer!

RJ45 connector for

the module (GST1

or GST2) to control

the thermostat with

a mobile phone

Fig.1 Fig.2

Fig.3

alkal.battery

1.5V/AA

alkal.batter

1.5V/AA

BATTERY REPLACEMENT

As soon as “ “ appears on the display, you must replace

the batteries.

1) Remove the control part from the lower cover of the device (Fig. 1).

2) Replace the batteries. Heed the correct polarity marked in the battery

compartment (Fig. 3). After removing the batteries, all setting of the

thermostat are saved in the E-EPROM memory. You only have to set

the time (page 5)!

Always use the type AA, 2 x 1.5 V, alkaline batteries!

Recommendation: Check the batteries before every heating season!

Dispose of old batteries in conformity with regulations

on hazardous waste treatment!

Product specificaties

Merk:	Elektrobock
Categorie:	Thermostaat
Model:	PT32

Heb je hulp nodig?

Als je hulp nodig hebt met Elektrobock PT32 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Thermostaat Elektrobock

Elektrobock BT730 Handleiding

12 Maart 2024

Elektrobock PT 32 GST Handleiding

11 September 2023

Elektrobock BPT 32 Handleiding

11 September 2023

Elektrobock PT 14 Handleiding

11 September 2023

Elektrobock PT 713 EI Handleiding

11 September 2023

Elektrobock PT 713 Handleiding

11 September 2023

Elektrobock BPT 22 Handleiding

11 September 2023

Elektrobock BT710 Handleiding

24 Juni 2023

Elektrobock BT102 Handleiding

6 Juni 2023

Elektrobock PT01 Handleiding

13 Mei 2023

Handleiding Thermostaat

Nieuwste handleidingen voor Thermostaat

Otio 840225 Handleiding

20 April 2024

Rose LM STH-FH100 Handleiding

16 April 2024

EMOS P5640S Handleiding

13 April 2024

Siemens Landis & Staefa REV22RF Handleiding

8 April 2024

Tylö CC300 Handleiding

20 Maart 2024

Tylö CC200 Handleiding

20 Maart 2024

Tylö CC300T Handleiding

20 Maart 2024

Siemens RDG160T Handleiding

17 Maart 2024

Nobo NTB-2T Handleiding

14 Maart 2024

Seitron TFD01M0001SE Handleiding

4 Maart 2024