Electro Harmonix Pico Rerun Handleiding

Bekijk gratis de handleiding van Electro Harmonix Pico Rerun (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 43 mensen en kreeg gemiddeld 4.4 sterren uit 3 reviews. Heb je een vraag over Electro Harmonix Pico Rerun of wil je andere gebruikers van dit product iets vragen? Stel een vraag

RERUN

User Manual

Tape Delay

RERUN

User Manual

Tape Delay

Tails and Analog Bypass Selection

The Rerun allows you to choose between two

bypass modes:

Analog: the bypass signal is fully analog; the

delay effect instantly mutes upon entering

bypass.

Tails: the repeats of the delay effect continue

to decay naturally upon entering bypass; no new

audio enters the delay block; bypass is digital.

Tails bypass is selected by default from the facto-

ry. To activate Analog bypass, do the following:

1. Press and hold the TYPE push button.

2. After two seconds, the LED enters Party Mode,

where it rapidly cycles through the three LED

colors.

3. Release the button; Analog bypass is now

active.

4. Repeat this same procedure to change back

to Tails bypass.

The bypass mode setting is remembered through

power-cycles so you can set it and forget it.

Maximum Feedback Self-Oscillation

Turn the FDBK knob up to maximum to achieve

runaway self-oscillation. When Tails bypass

mode is enabled, you can also activate maxi-

mum feedback by pressing and holding the

footswitch:

1. Press-and-hold the footswitch.

2. After 500ms, the LED begins flashing through

all three colors. Maximum Feedback is now

active.

3. Release the footswitch to stop self-oscillation

and return the feedback setting to the current

position of the FDBK knob.

Questions about this product? Email: info@ehx.com

Tails and Analog Bypass Selection

The Rerun allows you to choose between two

bypass modes:

Analog: the bypass signal is fully analog; the

delay effect instantly mutes upon entering

bypass.

Tails: the repeats of the delay effect continue

to decay naturally upon entering bypass; no new

audio enters the delay block; bypass is digital.

Tails bypass is selected by default from the facto-

ry. To activate Analog bypass, do the following:

1. Press and hold the TYPE push button.

2. After two seconds, the LED enters Party Mode,

where it rapidly cycles through the three LED

colors.

3. Release the button; Analog bypass is now

active.

4. Repeat this same procedure to change back

to Tails bypass.

The bypass mode setting is remembered through

power-cycles so you can set it and forget it.

Maximum Feedback Self-Oscillation

Turn the FDBK knob up to maximum to achieve

runaway self-oscillation. When Tails bypass

mode is enabled, you can also activate maxi-

mum feedback by pressing and holding the

footswitch:

1. Press-and-hold the footswitch.

2. After 500ms, the LED begins flashing through

all three colors. Maximum Feedback is now

active.

3. Release the footswitch to stop self-oscillation

and return the feedback setting to the current

position of the FDBK knob.

Questions about this product? Email: info@ehx.com

Product specificaties