Velleman KNS6 Handleiding

Bekijk gratis de handleiding van Velleman KNS6 (8 pagina’s), behorend tot de categorie Speelgoed. Deze gids werd als nuttig beoordeeld door 129 mensen en kreeg gemiddeld 4.2 sterren uit 2 reviews. Heb je een vraag over Velleman KNS6 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

KNS6 VELLEMAN 1

KNS6 – TRAINMECH

1. Introduction & Characteristics

Thank you for buying the KNS6 ! Read this manual carefully before bringing the KNS6 into use.

• Familiarise yourself with the operation of transmissions steered through gears or pulleys.

• Easy to build, no glue or soldering required.

• Dislodge the pre-cut pieces when you need them and not before. Sand the jagged edges before use (sandpaper

included)

• The kit is powered by 2 AA-batteries (not included).

The kits of the KNS-series are supplied with prepunched boards, a gearbox, gears, shafts, a switch, a motor, a

battery holder and all necessary parts.

Note that the figures with the assembly instructions can be found in the second folder “KNS6 – Figures”!!!

2. Parts List

Part n° Quant. Description Part n°Quant. Description

1 1 gearbox 17 2 pulley (15 x 1.9mm)

2 1 battery holder 18 2 nylon post (H = 6mm)

3 1 motor DC 6V 19 8 nylon post (H = 3mm)

4 20 1 slide switch with wire 3 PVC tube (15 x 1.5mm)

5 21 1 metal shaft (2 x 40mm) 8 nut M3

6 22 1 metal shaft (3 x 52mm) 4 screw (3 x 12mm)

7 23 5 metal shaft (2 x 60mm) 2 screw (3 x 16mm)

8 24 1 pinion gear 10T (white) 2 screw (3 x 20mm)

9 25 1 face gear (36T/14T) 8 washer (3.2 x 10 x 0.5mm)

10 1 gear 36T/0T 26 32 self-tapping screw (2 x 4mm)

11 1 gear (36T/14T) 27 2 self-tapping screw (2 x 6mm)

12 1 gear (36T/14T) 28 10 nylon pad (5.6 x 4.8 x 1.95mm)

13 29 1 wire with terminal (yellow) 10 nylon pad (Ø8mm)

14 30 1 wire with terminal (green) 10 nylon pad (6.6 x 4.8 x 2.1mm)

15 2 belt (40 x 1.2mm) 31 8 nylon connector (N-shaped)

16 32 2 pulley (15 x 2.9mm) 13 fixing plate (L-shaped)

3. Prepunched Boards (see “KNS6 – Figures

”

)

4. Assembly (see also “KNS6 – Figures

”

)

Fig. 3 : The gears (n°9/10/11/12) should be placed to the left of the pinion gear (n°8). Note that the protruding

edge should point towards the metal case.

Fig. 4 : Screw 1 x piece n°32 on boards 1 & 2 and attach them to boards n°3 & 4.

Product specificaties