VariZoom VZ-Rock-PZFI Handleiding

Bekijk gratis de handleiding van VariZoom VZ-Rock-PZFI (2 pagina’s), behorend tot de categorie Controller. Deze gids werd als nuttig beoordeeld door 56 mensen en kreeg gemiddeld 4.6 sterren uit 5 reviews. Heb je een vraag over VariZoom VZ-Rock-PZFI of wil je andere gebruikers van dit product iets vragen? Stel een vraag

VZ-ROCK-PZFI (ROCK-DVX-ZFI)

INSTRUCTIONS

Thanks for buying our new ZOOM/FOCUS/IRIS control for Panasonic camcorders. We think

you will enjoy this product, but before using it please read the instructions thoroughly.

WARNING:THIS IS NOT A “LANC” CONTROL DEVICE. DO NOT PLUG THE VZ-ROCK-PZFI INTO ANY

CAMCORDER OTHER THAN APPROVED PANASONIC UNITS. THIS REMOTE CONTROL SHOULD ONLY

BE PLUGGED INTO THE SPECIFIED ‘CAM REMOTE’ JACKS ON THE CAMCORDER BODY.

1. First, loosen the brass clamp nuts and fix the controller to

your tripod handle, jib, or shoulder support.

2. The split Y-cable has two connectors, one for the

zoom/record/pause circuit and another for the focus/iris

circuit. The zoom/record/pause connector is the smaller

plug that fits into the ‘ZOOM S/S’ jack. The focus/iris

connector is the larger plug that fits into the ‘FOCUS/IRIS’

jack.

3. To zoom in (telephoto) press the zoom ZOOM CONTROL -

rocker right, and to zoom out (wide) press the rocker left. The farther you press the

rocker, the faster the lens will zoom. The zoom characteristics of the ROCK-PZFI are

determined by the camera (e.g., the slowest zoom speed attainable with the DVX100B

takes 30 seconds from end--end). to

4. button. RECORD/PAUSE CONTROL - Start and stop recording by pressing the “R”

5. FOCUS CONTROL - To operate the remote focus control feature properly, the

‘FOCUS’ switch on the side of the camera lens should be set to ‘A’.Additionally, if

there is a master AUTO/MANUAL switch on the camera, set it to MANUAL.“”“” To

switch between autofocus and manual focus using your ROCK-PZFI, simply slide the

switch marked ‘Focus’ between ‘A’ (auto) and ‘M’ (manual). While the switch is set to ‘M’,

you can adjust the focus precisely using the large knurled dial on the left side of the

control.

-This dial has been designed so that you may either roll it using your operating thumb

or adjust it separately with your free hand.

-Note that your camera has addressable focus points indicated in the viewfinder by

“MF00 –MF99” (when in autofocus mode, it will read “AF00 –AF99”). This means

you can precisely rehearse or repeat focal adjustments without any guessing.

-While it is certainly possible to switch into autofocus mode for instant Special note -

quick-focus grabs using the controller, it is important to remember that when you

switch back to manual mode the camera will return to the focal point dictated by the

position of the dial on the controller. In other words, if your manual focus were set far

out to MF87 and you wanted to grab focus on a nearby moving object, you do so could

by switching into ‘A’ on the controller and letting the camera do the focusing, when but

you switch back to ‘M’ on the controller the camera will instantly return to MF87 (the

position in which the dial was left). ‘Push Auto’ is not available through the remote

Focus

Iris

Zoom

Product specificaties