Uline H-1335 Handleiding

Bekijk gratis de handleiding van Uline H-1335 (9 pagina’s), behorend tot de categorie Nietmachine. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.0 sterren uit 9 reviews. Heb je een vraag over Uline H-1335 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PAGE 1 OF 9 0424 IH-1335

H-1335

KIHLBERG PNEUMATIC

ROLL FEED STAPLER

1-800-295-5510

uline.com

WARNING! Read all warnings and instructions to

prevent injuries to yourself and to others.

• Use only original Kihlberg R555, R556 or R557 roll

staples with 15 or 18 mm leg length.

• Wear eye protection when using tool. Always use

other personal protection equipment as required,

such as ear protection, hard hats, etc.

• Never use oxygen, combustible gases, CO

2

, steam

or high pressure gas tanks as power sources for the

PN-version of this tool; the tool may explode and

cause serious injury. Use only dry, clean, pressure

regulated compressed air to drive the tool.

• Always assume stapler is loaded. Never point at

yourself or anyone else. Always remove finger from

trigger when not stapling.

• Always disconnect the tool from the air supply and

empty the magazine when taking a break or ending

work, when servicing the tool, troubleshooting or

repairing. Never leave a loaded tool unattended.

• Always check tool before every use.

• Never hold your hand or another part of your body

under the tool.

• Position yourself in a firmly balanced position when

using or handling the tool.

• Do not modify the tool or set it up in a jig without

manufacturer's approval.

• Use stapler with cardboard only. No other use is

permitted without the approval of the manufacturer.

Para Español, vea páginas 4-6.

Pour le français, consulter les pages 7-9.

SAFETY

OPERATION

ATTACH COMPRESSED AIR

CAUTION! Ensure the tool is not pointed at

you or anyone else when connecting it to the

compressed air line.

NOTE: The maximum permitted air pressure for

the tool is 8 bar (116 psi). The maximum supply

pressure is 8.78 bar (127 psi).

Connect the tool to the compressed air system before

the fastener unit is loaded.

NOTE: The tool and its hose can be equipped

with a connection nipple (not included) that

automatically exhausts air from the tool after it

has been disconnected.

Ensure the minimum internal diameter of the air hose is

10 mm (3/8") and that of the nipple is a minimum of

5 mm (6/32"). This prevents incorrect operation due to

excessive pressure drop.

AIR PRESSURE

Adjust the air pressure to the lowest setting that will bend

the staples correctly.

1. Start at 5.0 bar (72 psi).

2. Raise pressure by 0.5 bar (7 psi) increments until

correct pressure for the job is found.

CAUTION! Never exceed 8 bar (116 psi).

TOOL NEEDED

2.5 mm Allen Wrench

Product specificaties