StarTech.com UNIRAILS1U Handleiding

Bekijk gratis de handleiding van StarTech.com UNIRAILS1U (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 40 mensen en kreeg gemiddeld 4.4 sterren uit 8 reviews. Heb je een vraag over StarTech.com UNIRAILS1U of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Instruction Manual

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL:Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

Manual Revision: 10/26/2012

For the most up-to-date information, please visit: www.startech.com

Packaging Contents

• 1x Set Universal Rack Rails

• 8/16/14 x M5 Panel Screws (1U/2U/3U)

• 8/16/14 x M5 Cage Nuts (1U/2U/3U)

• 1x M5 Wrench

System Requirements

• Standard 19in wide rack

• 1U/ 2U/ 3U of rack space

UNIRAILS1U / UNIRAILS2U / UNIRAILS3U

1U/ 2U/ 3U Fixed 19” Adjustable Depth Universal Server Rack Rails

Installation

1. Determine the mounting depth of the rack/cabinet.

2. Gather the components of the two side rails. Each side rail is

comprised of 3 pieces: two End Rails with the rack mounting

brackets and the at middle section with the adjustable slide cut

outs.

NOTE: Look carefully at the End Rails, as there are two dierent sets.

The lip along the top edge will be taller on one set, than the other.

The side rails use one of each.

End Rail #2

Sliding Rail

End Rail #1

Tools Required

• Phillips screwdriver

3. Lay out the two End Rails end-to-end (rack mounting bracket at

opposite ends), and then place the Sliding Rail over top of the

smaller of the End Rail (see “Inside View” photo for reference).

Place the other End Rail overtop the Sliding Rail, so it is now

sandwiched between the two End Rails.

4. Adjust the length of the rails, such that the rack mounting

brackets are slightly longer than the mounting depth of the rack.

5. Fasten the middle Sliding Rail to each End Rail with 4 screws and

nuts each (2 on the top slide and 2 on bottom) with a screwdriver

and the provided wrench. The screw should go in from the inside

of the rail,with the nut on the outside (underneath the lip).

Inside View

*installation photos are for reference only

*actual product may vary from photos

Product specificaties