Rane MA 6s Handleiding
Rane
Mengpaneel
MA 6s
Bekijk gratis de handleiding van Rane MA 6s (8 pagina’s), behorend tot de categorie Mengpaneel. Deze gids werd als nuttig beoordeeld door 9 mensen en kreeg gemiddeld 4.3 sterren uit 5 reviews. Heb je een vraag over Rane MA 6s of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/8
MA 6s
MULTICHANNEL AMPLIFIER
POWER
3 6542
LEVEL
1
POWER
THERMAL
CLIP LIMIT CLIP LIMIT CLIP LIMIT CLIP LIMIT CLIP LIMIT CLIP LIMIT
SOA LIMIT SOA LIMIT SOA LIMIT SOA LIMIT SOA LIMIT SOA LIMIT
READY READY READY READY READY READY
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
MA 6S
BRIDGED BRIDGED
+4
+10
+20
dBu 0
+4
+10
+20
dBu 0
+4
+10
+20
dBu 0
+4
+10
+20
dBu 0
+4
+10
+20
dBu 0
+4
+10
+20
dBu 0
MULTI
CHANNEL
AMPLIFIER
BRIDGED
(INACTIVE)(INACTIVE) (INACTIVE)
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
To reduce the risk of electrical shock, do not open the unit. No user
serviceable parts inside. Refer servicing to qualied service personnel.
e symbols shown below are internationally accepted symbols that warn
of potential hazards with electrical products.
is symbol indicates that a dangerous voltage
constituting a risk of electric shock is present within
this unit.
is symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
WARNING
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, registers, stoves, or other apparatus (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A ground-
ing-type plug has two blades and a third grounding prong. e wide blade or third prong is provided for your safety. If the provided plug does not
t into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord and plug from being walked on or pinched particularly at plugs, convenience receptacles, and the point where it exits from
the apparatus.
11. Only use attachments and accessories specied by Rane.
12. Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply
cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
15. e plug on the power cord is the AC mains disconnect device and must remain readily operable. To completely disconnect this apparatus from
the AC mains, disconnect the power supply cord plug from the AC receptacle.
16. is apparatus shall be connected to a mains socket outlet with a protective earthing connection.
17. When permanently connected, an all-pole mains switch with a contact separation of at least 3 mm in each pole shall be incorporated in the electri-
cal installation of the building.
18. If rackmounting, provide adequate ventilation. Equipment may be located above or below this apparatus, but some equipment (like large power
ampliers) may cause an unacceptable amount of hum or may generate too much heat and degrade the performance of this apparatus.
19. is apparatus may be installed in an industry standard equipment rack. Use screws through all mounting holes to provide the best support.
WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture. Apparatus shall not be exposed to dripping
or splashing and no objects lled with liquids, such as vases, shall be placed on the apparatus.
NOTE: is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. ese
limits are designed to provide reasonable protection against harmful interference in a residential installation. is equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modications not expressly approved by Rane Corporation could void the user's authority to operate the equipment.
is Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Manual-1
OPERATORS MANUAL MA 6S
MULTICHANNEL AMPLIFIER
QUICK START
You gots your good habits, and you gots your bad habits. A
good habit is to read at least this much of the manual. A bad
habit is not to read any of this manual. Reading just this section
can prevent grief worse than your worst nightmare. Grief that's
hard to get rid of—harder than a bad habit.
Be sure the amplifier is before making any connections. off
Euroblocks make connecting and unconnecting the amplifier
easy. ey are just like little snap-on terminal blocks.e bal-
anced Input blocks are green, and the speaker Output blocks
are black. Driving the MA 6S from a balanced source is recom-
mended. If you just to drive the MA 6S Input with an have
unbalanced source, we recommend using cable that has two
conductors with a shield. Connect the sources positive or “hot”
to the MA 6S’s , the negative or ground to the MA 6S’s , and + –
connect the shield to the MA 6S’s (center of Euroblock SHIELD
connector). Do connect the shield at the source end. Keep not
your input cable lengths as short as possible. See the RaneNote,
“Sound System Interconnection” for more information regarding
this issue.
POWER
3 6542
LEVEL
1
POWER
THERMAL
CLIP LIMIT CLIP LIMIT CLIP LIMIT CLIP LIMIT CLIP LIMIT CLIP LIMIT
SOA LIMIT SOA LIMIT SOA LIMIT SOA LIMIT SOA LIMIT SOA LIMIT
READY READY READY READY READY READY
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
LEVEL
100
2
4
8
6
MA 6S
BRIDGED BRIDGED
+4
+10
+20
dBu
0
+4
+10
+20
dBu
0
+4
+10
+20
dBu
0
+4
+10
+20
dBu
0
+4
+10
+20
dBu
0
+4
+10
+20
dBu
0
MULTI
CHANNEL
AMPLIFIER
BRIDGED
(INACTIVE)(INACTIVE) (INACTIVE)
WEAR PARTS: is product contains no wear parts.
Speaker loads should be no less than 4 Ω per output. If you
are running multiple speakers per channel in series or parallel,
check your impedances, and consider the KTM 6 Transformer Kit
as an option (see Data Sheet). If you use 100V, 70.7V or 25V
output transformers, you need to engage the 80 Hz High-Pass
Filter jumpers as described on page Manual-6.
If you are running six separate channels (unbridged), be sure
all the switches on the rear panel are . If BRIDGED depressed
you are running any channels bridged, you are obviously a power
user and we highly recommend you read further into the manual
regarding this issue.
With Input and Output connections completed, be sure all
front panel controls are all the way counterclockwise. LEVEL
Now flip the switch and after hearing the relays click POWER
in after a second, notice that the lights come on. Slowly READY
turn up each channel's control to the desired gain and LEVEL
if all is well you should hear something pleasant. If not, re-check
connections, put on a better CD, and read more of the manual.
Product specificaties
| Merk: | Rane |
| Categorie: | Mengpaneel |
| Model: | MA 6s |
Heb je hulp nodig?
Als je hulp nodig hebt met Rane MA 6s stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Mengpaneel Rane
18 Juni 2025
18 Juni 2025
18 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
Handleiding Mengpaneel
- ATen
- Turmix
- Kenwood
- Avid
- RDL
- Wharfedale
- Caso
- Marquant
- Shure
- Philips
- Ariete
- Crown
- Roland
- OSD Audio
- Crestron
Nieuwste handleidingen voor Mengpaneel
17 Juni 2025
3 Juni 2025
21 Mei 2025
21 Mei 2025
21 Mei 2025
20 Mei 2025
20 Mei 2025
20 Mei 2025
19 Mei 2025
12 Mei 2025