Rane CP 62 Handleiding

Bekijk gratis de handleiding van Rane CP 62 (8 pagina’s), behorend tot de categorie Mengpaneel. Deze gids werd als nuttig beoordeeld door 13 mensen en kreeg gemiddeld 4.7 sterren uit 4 reviews. Heb je een vraag over Rane CP 62 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Manual-1

OPERATORS MANUALCP 62

COMMERCIAL PROCESSOR

QUICK START

This unit packs a lot of features, so let’s start by just getting some music running through it. Make all connections

with the power amplifiers off. The CP 62 must be earth grounded for safety and correct operation. Connect a wire to the

grounding screw (near the POWER input jack) to a known earth ground. The CP 62 can drive two zones with separate

program and levels. Zone 1 can be a stereo zone (determined by the MONO/STEREO MODE switch on the rear), we’ll

hook that up next. The zone outputs are fully balanced, so we recommend the use of balanced cables (¼" Tip-Ring-

Sleeve) to connect to the amplifier. If the amplifier’s inputs are unbalanced, the CP 62 still works fine using ¼" (Tip-

Sleeve) connectors if cable lengths are kept short (under 10 feet). Connect the CP 62 ZONE 1 LEFT and RIGHT

OUTPUTS to the amplifier inputs. Hook up a CD or tuner to PROGRAM INPUT 1using a standard stereo RCA cable.

Plug the RS 2 power supply into the red power connector on the back of the CP 62 and its line cord into the AC line—the

PWRLED should come on. Turn both ZONE LEVELcontrols fully counter clockwise. Turn the PROGRAM INPUT

LEVEL LINE 1up to 12 o’clock. Now it’s OK to turn on the amplifer. Slowly turn up ZONE 1 LEVEL. With the CD/

tuner playing, you should hear program coming from the speakers.

Now connect your other sources to the other PROGRAM INPUTS. Select each input with the ZONE 1 PROGRAM

SELECTswitch. Adjust individual source levels with the PROGRAM INPUT LEVELS. Adjust zone volume with the

ZONE LEVELcontrol. Tailor the zone 1 equalizer to your liking. Connect a second amplifer to the ZONE 2 OUTPUT

and run separate programs and levels to another room.

Never connect anything except an Rane RS 2 power supply to the thing that looks like a red telephone jack on

the rear of the CP 62. This is an AC input and requires special attention if you do not have an operational power supply

exactlylike the one originally packed with your unit.

Never connect anything except the optional Rane R1 zone assign or R2 source and level remote controls (or

their equivalent) to the things that look like black telephone handset jacks on the rear of the CP 62. These are not

telephone connections.

Product specificaties