Prier P-360 Handleiding

Bekijk gratis de handleiding van Prier P-360 (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.0 sterren uit 3 reviews. Heb je een vraag over Prier P-360 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

4515 E. 139th Street Grandview, MO 64030 | (800) 362-9055 | PRIER.com

P-360 IOM-C890-0046

HEX

1" FEMALE

NPT INLET

FINISHED

GRADE

Installation, Operation & Maintenance Instructions for the

PRIER P-360 Sanitary Bury Hydrant

Please leave this sheet for the property owner

1. Dig hole 2’ beyond bury depth (example: for a 5’ bury hydrant, dig a 7’

hole).

2. Install a large stone or block under the supply line to prevent sagging

and damage to the supply line. A set of boards attached directly below

the earth guard cap can be used as cross braces to support the hydrant

while inlet connections are made.

−IT IS IMPORTANT TO KEEP THE EARTH GUARD CAP

2-3" ABOVE GRADE FOR FUTURE HYDRANT SERVICING

−KEEP A MINIMUM OF 15" CLEARNACE FROM BASE OF

HYDRANT FOR FUTURE MAINTENANCE

1. The head is marked with “L” for Low Flow and “H” for High Flow. When the handle pin is aligned with the “L”,

water begins to ow. Desired ow can be achieved by aligning the handle pin with the desired ow mark.

2. Close handle slightly to lessen ow or completely to stop ow, allowing water to drain and be stored below the frost

line. *Water stored inside the sanitary canister is the rst to exit when re-opening the hydrant.

INSTALLATION

OPERATION

Unlike many ground hydrants, this sanitary hydrant is designed so the potable water system cannot cross contaminate with

polluted ground water. When the valve is turned to the off position, water from the valve drains into the sanitary canister

below the frost line. When turning on the hydrant, water from the sanitary canister is forced out of the canister, back into

the ow path. No winterization is needed for this hydrant. During freezing temperatures, hose must be detached and

hydrant turned off.

A code stamped into the handle stem pivot nut

(right) corresponds to the length, month and

year the hydrant was manufactured.

SCAN FOR VIDEO INSTRUCTIONS

For convenient maintenance, PRIER recommends installing a

shut-off valve in front of each hydrant.

3. Flush the water out of the supply line to remove foreign

particles before connecting the water line.

4. Connect the water line using a plastic (non- metallic)

adapter (Tee, 90° Elbow, etc.) to connect bury hydrant using

the 1” Female NPT inlet. Make sure to use thread sealant.

When tightening the hydrant use the hex provided at the

inlet of hydrant to prevent damage.

5. Before backlling, test the hydrant. Turn on water supply to

check for leaks and proper operation of the hydrant. Raise

and lower the lever several times. It is normal for some

water to

drain from the vacuum breaker holes when operating the

hydrant, but no water should drain beneath ground level.

6. Fill the bottom 30” of the hole with gravel to prevent the

area around the inlet connection from settling.

7. Make sure the hydrant is plumb and ll the remainder of

the hole with earth to match grade. Remember to ll to

the level designated by the label adhered to PVC body.

Product specificaties