Prier C-634BX1 Handleiding

Bekijk gratis de handleiding van Prier C-634BX1 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.4 sterren uit 9 reviews. Heb je een vraag over Prier C-634BX1 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

4515 E. 139th Street Grandview, MO 64030 | (800) 362-9055 | PRIER.com

Installation, Operation & Maintenance Instructions for the

PRIER C-633/C-634 Commercial Wall Hydrant

Please leave this sheet for the property homeowner

Thank you for purchasing the PRIER C-633/C-634 Commercial Wall Hydrant, the nest quality commercial

hydrant available. Your C-633/C-634 will provide you years of dependable service with little or no maintenance.

Please note: Your C-633/C-634 hydrant has drain holes under the packing nut. After shutoff, the drain holes will

allow water to drain for a few moments to prevent freezing. This is normal and according to design.

1. No special installation tools are required. Determine the location for installation of the hydrant. This valve

is designed for installation in either horizontal or vertical position. If installing vertically, install with hose

connection in “up” position.

2. Using the template provided on the box, bore a 1-3/8” diameter hole through the wall in the desired position,

and a ¼” alignment hole that is ½” deep.

3. Insert the hydrant through the hole and secure it to the inside wall using the provided wall clamping ring.

Seal through wall penetration if required.

4. Flush all foreign particles from the water line before connecting the hydrant.

5. Connect the water supply piping to the hydrant as desired. With a closed-end hose on the valve creating

back pressure, test the installation for leakage.

6. If planning to solder the hydrant to the supply piping, open the hydrant to the full open position before

soldering. Excess heat to the valve will damage the sealing surfaces on the stem of the hydrant.

INSTALLATION

Installation procedures may vary slightly depending on the seat option purchased and the installation inlet

options. The C-633/C-634 wall hydrant is available with the following inlet options:

Inlet StyleInlet Specications

N1” MPT x 3/4” FPT

P1” Male SWT x 3/4” Female SWT

V3/4” ProPress Ready

C-634 AND C-633NCC (Straight)

*P and V inlets not available on C-633NSV model

1. No special installation tools are required. Determine the location for

installation of the hydrant. This valve is designed for installation in either

horizontal or vertical position. If installing vertically, install with hose

connection in “up” position.

2. Using the provided template, Bore two holes through the wall and remove

the excess material between those to create an opening for the swivel inlet of

the valve.

3. Align your rotating inlet to the supply piping and secure the valve to the

outside wall. Seal through wall penetration if required.

4. Flush all foreign particles from the water line before connecting the hydrant.

5. Secure the hydrant to the supply piping and test for leakage with a closed-

end hose as described above.

C-633NSV (Swivel)

Acceptable

Recoendmmed

Acceptable

Not Recommended

Product specificaties