Microchip 34VL02 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Microchip 34VL02 (32 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32
© 2008 Microchip Technology Inc. DS22079A-page 1
34VL02
Features:
• Permanent and Resettable Software Write-Protect
for Lower Half of the Array (00h-7Fh)
• Single Supply with Operation Down to 1.5V
• Low-Power CMOS Technology:
- Read current 1 mA, typical
- Standby current, 100 nA, typical
• 2-Wire Serial Interface Bus, I2C™ Compatible
• Cascadable up to Eight Devices
• Schmitt Trigger Inputs for Noise Suppression
• Output Slope Control to Eliminate Ground Bounce
• 100 kHz and 400 kHz Compatibility
• Page Write Time 3 ms, typical
• Self-Timed Erase/Write Cycle
• 16-Byte Page Write Buffer
• ESD Protection > 4,000V
• Hardware Write Protection for Entire Array
• More than 1 Million Erase/Write Cycles
• Data Retention > 200 Years
• 8-Lead PDIP, SOIC, TSSOP, MSOP and TDFN
packages
• 6-Lead SOT-23 Package
• Pb-free and RoHS Compliant
• Temperature Range:
- -20°C to +85°C
Device Selection Table
Package Types
Description:
The Microchip Technology Inc. 34VL02 is a 2 Kbit
Electrically Erasable PROM capable of operation
across a broad voltage range (1.5V to 3.6V). This
device has two software write-protect features for the
lower half of the array, as well as an external pin that
can be used to write-protect the entire array. This
allows the system designer to protect none, half, or all
of the array, depending on the application. The device
is organized as one block of 256 x 8-bit memory with a
2-wire serial interface. Low-voltage design permits
operation down to 1.5V, with standby and active cur-
rents of only 100 nA and 1 mA, respectively. The
34VL02 also has a page write capability for up to 16
bytes of data. The 34VL02 is available in the standard
8-pin PDIP, surface mount SOIC, TSSOP, MSOP and
TDFN packages. The 34VL02 is also available in the
6-lead, SOT-23 package.
Part Number VCC
Range
Max. Clock
Frequency
34VL02 1.5-3.6 400 kHz(1)
Note 1: 100 kHz for VCC <1.8V
A0
A1
A2
VSS
1
2
3
4
8
7
6
5
VCC
WP
SCL
SDA
PDIP/SOIC/TSSOP/MSOP/TDFN
A0
A1
A2
V
SS
WP
SCL
SDA
V
CC
8
7
6
5
1
2
3
4
SOT-23
6
2
4
SDA
VCC
VSS A0
A1
5
3
1SCL
2K I2C™ Serial EEPROM Software Write-Protect
34VL02
DS22079A-page 2 © 2008 Microchip Technology Inc.
Block Diagram
I/O
Control
Logic
Memory
Control
Logic XDEC
HV Generator
Standard
Array
Software write-
Write-Protect
Circuitry
YDEC
VCC
VSS
Sense Amp.
R/W Control
SDA SCL
A0 A1 A2 WP
protected area
(00h-7Fh)
© 2008 Microchip Technology Inc. DS22079A-page 3
34VL02
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings(†)
VCC.............................................................................................................................................................................6.5V
All inputs and outputs w.r.t. VSS ..........................................................................................................-0.3V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied..................................................................................................-20°C to +85°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. These are stress ratings only and functional operation of the device at these or any other conditions above
those indicated in the operation sections of the specifications is not implied. Exposure to Absolute Maximum Rating
conditions for extended periods may affect device reliability.
TABLE 1-1: DC SPECIFICATIONS
DC CHARACTERISTICS VCC = +1.5V to +3.6V
Temperature Range: -20°C to +85°C
Param.
No. Symbol Characteristic Min. Typ. Max. Units Conditions
—A0, A1, A2, SCL, SDA
and WP pins
— — — — —
D1 VIH High-level input voltage 0.7 VCC — — V —
D2 VIL Low-level input voltage — — 0.3 VCC V 0.2 VCC CC for V < 2.5V
D3 VHYS Hysteresis of Schmitt
Trigger inputs
0.05 VCC — — V (Note)
D4 VOL Low-level output voltage — — 0.40 V IOL = 3.0 mA, VCC = 2.5V
D5 VHV High-Voltage Detect 7 — 10 V A0 Pin only, VCC < 2.2V
VCC + 4.8 — 10 V A0 Pin only, VCC ≥ 2.2V
D6 ILI Input leakage current — — ±1 μA VIN = VSS or VCC
D7 ILO Output leakage current — — ±1 μA VOUT = VSS or VCC
D8 CIN,
COUT
Pin capacitance
(all inputs/outputs)
— — 10 pF VCC = 3.6V (Note)
TA = 25°C
D9 ICC write Operating current — 0.1 3 mA VCC = 3.6V
D10 ICC read — 0.05 1 mA —
D11 ICCS Standby current — 0.01 1 μA SDA = SCL = VCC
A0, A1, A2, WP = VSS
Note: This parameter is periodically sampled and not 100% tested.


Product specificaties

Merk: Microchip
Categorie: Niet gecategoriseerd
Model: 34VL02

Heb je hulp nodig?

Als je hulp nodig hebt met Microchip 34VL02 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Microchip

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd