Joy-it COM-ZY12PDG Handleiding

Joy-it Niet gecategoriseerd COM-ZY12PDG

Lees hieronder de 📖 handleiding in het Nederlandse voor Joy-it COM-ZY12PDG (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

USB PD TRIGGER MODULE-

COM ZY12PDG-

1. GENERAL INFORMATION

Dear customer,

Thank you for purchasing our product. In the following, we will show you

which things should be noted during the use.

Should you encounter any unexpected problems, do not hesitate to

When using the module, make sure to use a suicient cable

cross section.-

To use the module as intended, you need a USB capable power -PD-

supply unit.

2. INTERFACE

The trigger pin on the board has the same function as the button. By set-

ting the pin LOW, pressing the button is simulated.

Ground

VBUS

Trigger pin

CC2

CC1

USB Type C-

Ground

VBUS

3. OPERATION

Connect your USB PD trigger module to a USB PD compatible power - -

supply using the interface explained above. The free solder pads on the

back of the board are used to connect the load. These modules provide

you with dierent voltage modes, which are indicated by the LED.

Colour Voltage mode

■ 5 V

■ 9 V

■ 12 V

■ 15 V

■ 20 V

■ Maximum possible voltage of

the power supply

■ Runs through all modes

(one per second)

To set the modes as default, first plug the board into your power supply

while holding down the button on the board. Now the LED will start

flashing colourfully. Now you can select the desired mode using the

button. Now press and hold the button to confirm your selection. Finally,

disconnect the power supply from the module and then reconnect it so

that the module now starts directly in this mode.

Product specificaties

Merk:	Joy-it
Categorie:	Niet gecategoriseerd
Model:	COM-ZY12PDG
Breedte:	20 mm
Diepte:	15 mm
Hoogte:	3.5 mm
Stroom:	5 A
Vermogensverbruik (max):	100 W
Ingangsspanning:	5 - 20 V