Johnson Control T600MEP-3 Handleiding

Bekijk gratis de handleiding van Johnson Control T600MEP-3 (17 pagina’s), behorend tot de categorie Thermostaat. Deze gids werd als nuttig beoordeeld door 25 mensen en kreeg gemiddeld 4.4 sterren uit 8 reviews. Heb je een vraag over Johnson Control T600MEP-3 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

T600MEP-3 Multi-stage Economizer Thermostat Installation Instructions1

Applications

The T600MEP-3 programmable thermostats are

specifically designed for control of rooftop units with

economizers.

North American Emissions Compliance

United States

This equipment has been tested and found to comply

with the limits for a Class A digital device pursuant to

Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference when this equipment is operated in a

commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the

instruction manual, may cause harmful interference to

radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference,

in which case the user will be required to correct the

interference at his/her own expense.

Canada

This Class (A) digital apparatus meets all the

requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numérique de la Classe (A) respecte

toutes les exigences du Règlement sur le matériel

brouilleur du Canada.

Installation

Location Considerations

Locate the T600MEP-3 thermostat:

•on a partitioning wall, approximately 5 ft (1.5 m)

above the floor in a location of average

temperature

•away from direct sunlight, radiant heat, outside

walls, behind doors, air discharge grills, stairwells,

or outside doors

•away from steam or water pipes, warm air stacks,

unconditioned areas (not heated or cooled), or

sources of electrical interference

Note: Allow for vertical air circulation to the

T600MEP-3 thermostat.

To install the thermostat:

1.Use a Phillips-head screwdriver to remove the

security screw on the bottom of the thermostat

cover.

2.Pull the bottom edge of the thermostat cover and

open the thermostat as illustrated in Figure 1.

IMPORTANT: The T600MEP-3 Thermostat is

intended to provide an input to equipment under

normal operating conditions. Where failure or

malfunction of the thermostat could lead to personal

injury or property damage to the controlled

equipment or other property, additional precautions

must be designed into the control system.

Incorporate and maintain other devices such as

supervisory or alarm systems or safety or limit

controls intended to warn of or protect against failure

or malfunction of the thermostat.

Figure 1: Removing the Thermostat Cover

FIG:cvr_rmvl

T600MEP-3 Multi-stage Economizer Thermostat

Installation Instructions

T600MEP-3 Part No. 24-9890-609, Rev. —

Issued September 20, 2006

Product specificaties