EK Water Blocks 3831109869093 Handleiding

Bekijk gratis de handleiding van EK Water Blocks 3831109869093 (2 pagina’s), behorend tot de categorie Hardwarekoeling. Deze gids werd als nuttig beoordeeld door 77 mensen en kreeg gemiddeld 4.9 sterren uit 8 reviews. Heb je een vraag over EK Water Blocks 3831109869093 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 25

th

of April 2014.

Installation and mounting manual for EK-FC R9-295X2 Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of AMD Radeon R9 295X2 graphics card

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FCR9-295X2 Backplate is very easy to install. First install EK-FC R9-295X2 water block according to its manual. If you have it already installed

the water block please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Please

remove the eight (8) screws marked with arrow. Apply thermal pads on RAMs 2x Thermal Pad D – 0.5mm (8xRAM).

STEP 3: APPLYING THE THERMAL PADS

EK-FCR9-295X2 Backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the enclosed

thermal pad. Please install enclosed 0,5mm thick thermal pad (Thermal Pad A – 0,5mm (100x16)) and 1,5mm thick thermal pad (Thermal Pad C –

1,5mm (50x25)) directly on the large extruded stub on the back plate itself as shown on the picture below. You need to trim the excess thermal

pad.

EK-FC R9-295X2 Backplate

Thermal pad A - 0,5mm

(100x16mm)

Thermal pad C - 1,5mm (50x25mm)

1

1

1

1

1

1

1

1

2

2

3

3

2

Product specificaties