CTA Digital PAD-SSMANS Handleiding

Bekijk gratis de handleiding van CTA Digital PAD-SSMANS (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 4.4 sterren uit 4 reviews. Heb je een vraag over CTA Digital PAD-SSMANS of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Slim Spring Arm Mount w/ USB Ports and

Universal Security Enclosure for Medium Size Tablets

PAD-SSMA

INSTRUCTION - MANUAL

CONTENTS:

2

1

3

888-733-4448

PRE-SETUP

INSTALLATIONS:

SETTING UP CLAMP MOUNT OPTION

SETTING UP GROMMET MOUNT OPTION

1B. Prior to beginning the grommet or clamp

installation - press the USB cables into the groove

as shown to properly setup.

2A. Align L-shape component(F) with base of clamp mount

as shown above. Rotate in screws (K) through using

provided tool (P) until securely tighten. Afterwards peel off

sticker back of padding (N) and place firmly on the screws

(K).

2B. Identify the overall thickness of the surface the clamp will be mounting on. If the thickness is in the 10-55mm range, you

will be using the higher setting on the L-shape bracket of the base. If the thickness is in the 50-85mm range, you will be using

the lower setting. Rotate in the screws (F) of the bracket until halfway in leaving some space. Hook on the knob component

(E). After hooked on, use the provided tool (P) and securely tighten the screws (F) until securely fastened.

2C. Rotate knob (E) until securely tighten to

fasten clamp to surface.

3A. Align base (G) with component (H). Rotate in screws (K)

with provided tool (P) until securely tightened. After, locate

base pads and remove backing. Place adhesive side of pads

on the screws as illustrated above.

3B. Using drill (not included), drill a 10mm diameter

hole for the grommet mount installation. If existing

hole is available, make sure diameter is in the

10-60mm range prior to setup for proper installation.

3C. Align base (G) with pre-drilled hole and insert

long screw (J) through the base and hole. From

below insert grommet mount components (I, L, M)

onto the long screw. Using fingers initially, rotate all

the grommet components until tightly fastened.

Using provided wrench tool (R),rotate hex nut (M)

until securely tightened.

3D. Take the bottom part of the clamp arm (B) and

insert the bottom connector into the base (G) as

illustrated above. Then tighten with provided tool (P)

until securely fastened. Then take the top part of

clamp arm (A) and insert into top connector part of

the bottom arm. Tighten joint with provided tool (P)

as illustrated.

**Powerdrill not

included and for

illustration

purposes only

Security VESA

Plate Option using

provided (P) tool to

lock/unlock

Non-Security VESA

Plate Option with

knob turn to

lock/unlock

Foam Adapter & Sheet Bundle

S

T

U

2

Product specificaties