CTA Digital PAD-GSMAR Handleiding

Bekijk gratis de handleiding van CTA Digital PAD-GSMAR (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.7 sterren uit 4 reviews. Heb je een vraag over CTA Digital PAD-GSMAR of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Gas Spring Clamp Mount with 2 USB Ports for Medium Size Tablets

PAD-GSMAG / PAD-GSMAR

888-733-4448

INSTRUCTION - MANUAL

CONTENTS:

2

3

1

PRE-SETUP

INSTALLATIONS:

SETTING UP CLAMP MOUNT OPTION

SETTING UP GROMMET MOUNT OPTION

1A. Firmly hold the two halves of the spring arm

together and have another person cut off the

cable tie from around the spring arm. Slowly

release the pressure on the spring arm and allow

it to gradually stretch to its full extension.

1B. Prior to beginning the grommet or clamp

installation - press the USB cables into the groove

as shown to properly setup.

2A. Align L-shape component(D) with base of clamp mount

as shown above. Rotate in screws (O) through using

provided tool (Q) until securely tighten. Afterwards peel off

sticker back of padding (N) and place firmly on the screws

(O).

2B. Identify the overall thickness of the surface the clamp will be mounting on. If the thickness is in the 10-55mm range, you

will be using the higher setting on the L-shape bracket of the base. If the thickness is in the 50-85mm range, you will be using

the lower setting. Rotate in the screws (D) of the bracket until halfway in leaving some space. Hook on the knob component

(E). After hooked on, use the provided tool (Q) and securely tighten the screws (D) until securely fastened.

2C. Clip on tool cradle (G) on the back as

illustrated.

3A. Alight grommet mount (K) with base of clamp mount as

shown above. Rotate in screws (O) until securely fastened.

3B. Using drill (not included), drill a 10mm diameter

hole for the grommet mount installation. If existing

hole is available, make sure diameter is in the

10-60mm range prior to setup for proper installation.

3C. Insert the grommet mount (K) with clamp as

shown. Once through the surface, rotate in the rest

of the grommet mount components (J, L, M) using

your hands initially. Make sure all the components

are rotated as far as you can go with no space gaps.

3D. Using provided tool (S), rotate in the hex nut (M)

until securely tightened.

**Powerdrill not

included and for

illustration

purposes only

Security VESA

Plate Option using

provided (P) tool to

lock/unlock

Non-Security VESA

Plate Option with

knob turn to

lock/unlock

M5 Nut 6mm

(x4)

V

M5 x 10

(x4)

Y

M5 Allen Key

(x1)

Z1

(x4)

W

(x4)

X

(x1)

Z

(x1)

T

(x1)

U

Foam Adapter &

Sheet Bundle

Product specificaties