CRUX SWRSU-38A Handleiding
CRUX
Niet gecategoriseerd
SWRSU-38A
Bekijk gratis de handleiding van CRUX SWRSU-38A (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 67 mensen en kreeg gemiddeld 4.5 sterren uit 34 reviews. Heb je een vraag over CRUX SWRSU-38A of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/3
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.031220
SWRSU-38A
Radio Replacement with Steering Wheel Control Retention for
Select SUBARU Vehicles 2007 - 2009
1 of 3
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Subaru vehicles while funconing with an aermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- EIA color coded wiring for easy installaon.
PRODUCT FEATURES:
PARTS INCLUDED:
SWRSU-38A Module SWRSU-38A T-Harness SWC Cable
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
4-Pin
Connector
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
+12V Constant Yellow
+12V ACC Red
Ground Black
Antenna Power Blue
TO FACTORY
HARNESS
12-Pin Black
Connector
AFTERMARKET
RADIO SELECTOR
(See Page 2)
SUBARU
SWC SETTING
(See Page 2)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
8 Pin Connector
14 Pin Connector
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.031220
SWRSU-38A
Radio Replacement with Steering Wheel Control Retention for
Select SUBARU Vehicles 2007 - 2009
2 of 3
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
DIP SWITCH SETTINGS:
SUBARU STEERING WHEEL CONTROL DIP SWITCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
NOTE: Insulate the Blue/Yellow and Green wires if not being used.
RADIO BRAND: DIP: 1 2 3 4
Atoto, Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most o-brand Radios
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios,
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
INSTALLATION INSTRUCTIONS:
1. Carefully remove the gear shier
trim ring.
2. Use a plasc pry bar and carefully li
and remove the gear shier trim bezel.
3. Unplug the cigaree lighter
connecon.
DIP: 5 6 7 8
Panasonic made Radio
Clarion made Radio*
Clarion made Radio**
Fujitsu Ten made Radio
ON OFF OFF ON
OFF ON OFF ON
ON OFF ON OFF
OFF ON OFF ON
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
For aermarket radios that have wires for SWC connecons, cut o the 3.5mm plug on the Crux SWC Cable (opon B) and
connect the SWC wires as follows:
Note that there are some radios that only have
SWC1 and SWC2, in this case “shield” does not
need to be connected.
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.031220
SWRSU-38A
Radio Replacement with Steering Wheel Control Retention for
Select SUBARU Vehicles 2007 - 2009
3 of 3
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
4. Remove the screws holding the le
and right side trims.
5. Remove the le and right side trims. 6. Remove the screws holding the
radio.
7. Unplug the hazard light connector. 8. Unplug the connectors behind the
radio.
9. Note that the SWC connecon is
made on the 8-pin connector.
8. Use the necessary dash kit (not included) to complete the installaon. Connect
the aermarket radio wires to the SWRSU-38A T-harness.
9. Plug in the SWRSU-38A 8-pin SWC connector to the factory mate.
10. Conrm the DIP Switch sengs and test the steering wheel controls for
funconality.
11. Test the radio for other funconality before installing the new radio into the
dash. Reverse the radio removal process.
VEHICLE APPLICATIONS:
SUBARU
2007-2009
2007-2009
Legacy (without Automac Climate Controls)
Outback (without Automac Climate Controls)
Product specificaties
| Merk: | CRUX |
| Categorie: | Niet gecategoriseerd |
| Model: | SWRSU-38A |
Heb je hulp nodig?
Als je hulp nodig hebt met CRUX SWRSU-38A stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Niet gecategoriseerd CRUX
10 Maart 2025
10 Maart 2025
10 Maart 2025
10 Maart 2025
9 Maart 2025
9 Maart 2025
9 Maart 2025
9 Maart 2025
9 Maart 2025
9 Maart 2025
Handleiding Niet gecategoriseerd
- Juki
- Shark
- Engel
- Playseat
- A.O. Smith
- Moxa
- Hamlet
- Smith & Wesson
- Qu-Bit
- Platinum Tools
- EQ Acoustics
- Trust
- Horizon Fitness
- Contax
- Wampler
Nieuwste handleidingen voor Niet gecategoriseerd
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025