CRUX SWRTY-61C Handleiding

Bekijk gratis de handleiding van CRUX SWRTY-61C (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 65 mensen en kreeg gemiddeld 4.1 sterren uit 7 reviews. Heb je een vraag over CRUX SWRTY-61C of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.052020

SWRTY-61C

Radio Replacement with Steering Wheel Control Retention for

Select Toyota Vehicles 2018-Up

1 of 3

RAD IO RE PLACEMENT

SWC RETE NTION

+

R

INTERFACING SOLUTIONS

- Retains factory features in select Toyota vehicles while funconing with an aermarket radio.

- Pre-programmed to retain factory Steering Wheel Controls.

- Retains the factory amplier (non JBL). For vehicles with factory JBL amplier use part# SWRTY-61P.

- Retains factory back-up camera.

- Retains factory Auxiliary Audio Input.

- Includes factory USB retenon adapter cable.

- Includes antenna adapter.

PRODUCT FEATURES:

PARTS INCLUDED:

SWRTY-61C ModuleTY-61C HarnessSpeaker HarnessSWC Cable USB Adapter

INSTALLATION DIAGRAM:

AFTERMARKET

RADIO

+12V Constant Yellow

+12V ACC Red

Ground Black

Reverse Gear Output Red/White

Vehicle Speed Sense Pink

Parking Brake Output Light Green

Amp Turn On Blue/White

Right Front (+) Gray

Right Front (-) Gray/Black

Left Front (+) White

Left Front (-) White/Black

Right Rear (+) Violet

Right Rear (-) Violet/Black

Left Rear (+) Green

Left Rear (-) Green/Black

Audio Input Red/White RCA

(Retains Factory AUX Input)

TO FACTORY

HARNESS

12-Pin Black

Connector

30 PIN

USB Retention Adaptor

(included in kit)

ANTENNA ADAPTOR

(Included in Kit)

Blue / Antenna Turn On

28 PIN

Yellow RCA

(Retains OE Camera)

Rear View Camera Signal Output

AFTERMARKET

RADIO SELECTOR

(See Chart)

TOYOTA

SWC SETTING

(OFF ON OFF ON)

ON RADIOVEHICLE

1 2 3 4 5 6 7 8

ON RADIOVEHICLE

1 2 3 4 5 6 7 8

4-Pin

Connector

Cap or insulate if

not being used

Kenwood/JVC (BLUE / YELLOW)

Insulate with tape

if not being used

3.5MM SWC CABLE

Plug in the 3.5MM SWC cable to the 4-pin port

on the module. See below for DIP switch settings.

To aftermarket

radio SWC wire

or 3.5mm port

To aftermarket radio

Remote Turn On wire

(Blue or Blue/White wire)

To aftermarket radio Aux Input

Product specificaties