Cotech AR0027 Handleiding

Bekijk gratis de handleiding van Cotech AR0027 (5 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 36 mensen en kreeg gemiddeld 4.8 sterren uit 6 reviews. Heb je een vraag over Cotech AR0027 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

GREAT BRITAIN • CUSTOMER SERVICE

contact number: 08545 300 9799

e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk

ENGLISH

1

2

3

4

5

67 89

10

11

Ver. 20131209

ALBIN LED Wall Light

Art.no 36-4855 Model AR0027-black

Please read theentire instruction manual before using theproduct and save it for future reference.

We reserve theright for any errors in text or images and any necessary changes made to technical data.

If you have any questions regarding technical problems please contact our Customer Services.

1. Location1. UndotheM6 bolts and take off thewall bracket (2).

Don’t mix thewashers up.

2. Markout theposition of themounting holes on

thewall using thewall bracket as atemplate.

Drillholes for themounting screws (1). Usesuitable

screws and wall plugs if necessary. Thefloodlight

must be fixed securely. Beforestarting to drill, check

that there are no hidden electrical cables or water

pipes in thewall.

3. Removethebolts holding thejunction box cover

on, remove thecable gland and thestrain relief and

thread thepower cable (3G, 0.75) into thejunction

box through thecable gland and rubber grommet.

4. Connect thethree wires: L- Live (brown), N - Neutral

(blue) and - Electrical earth (green/yellow) to

theterminal block as marked in thejunction box.

Consider thefollowing

advice:

• The most suitable

height to mount

thelight at is

1.8–2.5m above

theground.

• Ideally, thelight

should be horizontal.

2. Installation

1. Wall screws

2. Wall bracket

3. Spring washer

4. Plain washer

5. M6bolt

6. Cablegland

7. Rubber

grommet

8. Lamp housing

9. Terminal block

10. Cable strain

relief withbolts

11. Junction

box cover

(withbolts)

5. Pushtheterminal block into thejunction box and

clamp thecable in place using thestrain relief.

Thenrefit thejunction boxcover.

6. Boltthelamp housing to thewall bracket.

7. Tiltthelamp housing to thedesired angle and tighten

thebolts (1).

8. Replace thefuse.

3. Disposal

This product should be disposed of in accordance with

local regulations. If you are unsure how to proceed,

contact your local authority.

4. Technical data

Ideal for use with motion detectors.

Mains supply 220–240 V AC, 50Hz

Power 20 W

Light source 14×1 W LED (non-replaceable)

Bright LEDs (6,500 K), 770lm

Aperture210×130 mm

Protection class IP44 (approved for outdoor use)

Safety class Class 1 (this light fitting must

be earthed)

Important: Readtheentire instruction manual before

installation. Theinstallation should be carried out by

aqualified electrician and conform to current regulations.

Warning: Makesure that thepower is turned off and that

thefuse is removed before beginning any installation,

change of light bulb or service.

Product specificaties