Azden SMX-10 Handleiding

Bekijk gratis de handleiding van Azden SMX-10 (2 pagina’s), behorend tot de categorie Microfoon. Deze gids werd als nuttig beoordeeld door 25 mensen en kreeg gemiddeld 4.7 sterren uit 8 reviews. Heb je een vraag over Azden SMX-10 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Thank you for purchasing the Azden SMX-10 stereo microphone. The SMX-10 is designed for videographers

that require high quality stereo sound pick-up.

BATTERY:

Unscrew the lower half of the microphone by turning the

case counter clockwise. Insert one AAA battery into the

case. Check for correct polarity. Replace the case and turn

clockwise to tighten. Do not over tighten or you may

damage the threads.

PLUG-IN POWER:

The SMX-10 may also operate on “plug-in power” if

provided by the connected camera’s microphone input. In

this case a battery is not required. However, for best

performance the use of a fresh battery is recommended.

MICROPHONE HOLDER:

Snap the microphone into the holder towards the back of the case. Slide the holder onto the

shoe mount of the camera and tighten the wheel until snug. Do not over tighten or you may

damage the threads.

WINDSCREEN:

Slide the windscreen over the front end of the microphone and cover all the vents on the

case.

OUTPUT CABLE:

Plug the microphone’s output cable into the “Ext. Mic” input jack on your camera.

POWER SWITCH:

Switch to “ON” for normal operation using battery power.

Switch to “OFF” to avoid draining the battery and/or to use plug-in power.

Note: The SMX-10 will continue to operate even when the power switch is turned off and/or a battery

is not installed if plug-in power is provided by the microphone input jack.

LOW CUT FILTER SWITCH:

: Turn the low cut filter switch to “ON” to reduce low frequency sounds and

increase clarity.

: Turn the low cut filter switch to “OFF” for flat response and maximum bass.

SMX-10 STEREO MICROPHONE INSTRUCTION MANUAL

＋

−

0゜

90゜

270゜0.50.5

180゜

0.5

0.5

1kHz

R ch

0゜

90゜

270゜0.50.5

180゜

0.5

0.5

1kHz

L ch

SPECIFICATIONS

Type: Stereo Electret Condenser

Sensitivity: -40 dB (at 1 kHz 1 V/Pa)

Frequency Response: 100 – 20,000 Hz

Output Impedance: 1.5 kΩ (at 1 kHz)

Power Source: DC 1.5 V AAA size battery

Max. SPL: 100 dB

Signal Noise Ratio: More than 60 dB

Plug Cord Assembly: Coiled cord with φ 3.5 mm plug

POLAR PATTERN

Product specificaties