Apc NBES0307 Handleiding

Apc Server NBES0307

Bekijk gratis de handleiding van Apc NBES0307 (4 pagina’s), behorend tot de categorie Server. Deze gids werd als nuttig beoordeeld door 46 mensen en kreeg gemiddeld 4.3 sterren uit 23.5 reviews. Heb je een vraag over Apc NBES0307 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Pagina 1/4
NetBotz® Smoke Sensor (NBES0307)
Installation Instructions
WARNING: The NetBotz Smoke Sensor is intended to provide supplementary
protection for equipment in data center racks and enclosures only. It is not to be
used to protect structures or personnel.
This Smoke Sensor includes a System Senso model 4W-B, I3 Series, Photoelectric
Smoke Detector. For complete safety, installation, operation, and maintenance
information, refer to the I3 Series Installation and Maintenance Instructions on the
System Sensor Web site, www.systemsensor.com.
Inventory
Smoke sensor with 3.05-m (10-ft)
cable (1)
M4 x 8 pan head screw (2) M6 black plastic cup
washer (2)
Smoke sensor bracket (1) M6 x 16 Phillips slot screw (2) M3 knurled thumb nut (2)
203-mm (8-in) tie wrap (10) Adhesive cable tie holder (5) M3 x 12 stud fastener (2)
RJ-45 coupling (1)
NetBotz Smoke Sensor (NBES0307) Installation Instructions2
Installation
Caution: Make sure you connect this sensor to a Sensor port on applicable NetBotz
products. See your NetBotz product documentation for details.
Caution: Make sure you remove the orange protective cover shown in step three.
Note: Smoke detection is best when you install the sensor near the top of the enclosure. The
sensor occupies one U-space.
Note: You can extend the length of the sensor cable up to 30.5 m (100 ft) using the
RJ-45 coupling and standard CAT-5 cabling.
Note: Use adhesive cable tie holders and tie wraps to secure the sensor cable.
OR
NetBotz Smoke Sensor (NBES0307) Installation Instructions 3
Operation
The Smoke Sensor LEDs function as follows:
Both LEDs will blink simultaneously once every ten seconds during the power-up sequence.
The green LED will blink once every five seconds to indicate normal operation.
The red LED will blink once every five seconds to indicate that the Smoke Sensor is out of
sensitivity.
The red LED will turn on when the Smoke Sensor reports an alarm state.


Product specificaties

Merk: Apc
Categorie: Server
Model: NBES0307

Heb je hulp nodig?

Als je hulp nodig hebt met Apc NBES0307 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden