Apc Back- 500 Handleiding

Bekijk gratis de handleiding van Apc Back- 500 (4 pagina’s), behorend tot de categorie UPS. Deze gids werd als nuttig beoordeeld door 9 mensen en kreeg gemiddeld 4.4 sterren uit 3 reviews. Heb je een vraag over Apc Back- 500 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

INSTALLATION

w

w

w

.apc.com

®

Back-UPS HS 500

User’s Manual

990-9236 3/04

3Remove Battery (if wall-mounting - if not proceed at Step 5)

0 - 40oC (32 - 104oF)

1Placement 2Remove Connector Cover

Disconnect battery

wires from battery.

Remove battery.

Press cover release

tab (one each side)

and remove cover.

Caution: To prevent damage to the ribbon cable (not shown)

that connects the cover to the UPS, replace the cover after

removing the battery. Do not disconnect the ribbon cable

from the cover or the UPS.

Press the outlet cover release

tab (one each side); and pivot

cover off the unit.

Phone Line Out

4Mount Back-UPS (optional)

Wall Anchor

Mounting

Hole

Wall

5Connect/Install Battery, Install Battery Cover

Install battery cover.

Connect and install

the battery.

Press the outlet cover

release tab (one each

side); and pivot cover

off the unit.

6Connect Cable Modem,

Circuit Breaker

Push to Reset

Cable Out

Input:

230V~, 2.2A, 50-60Hz

Cable In

From Cable Provider

(Phone, Internet,

and/or CATV; or

DSS)

To Cable Modem,

VCR, DSS or TV

Cable Box

7Connect Phone Line

LAN

NetworkModem/Phone/Fax

RJ-45

Connectors

(can accept RJ-11)

RJ-45

Connectors

Phone Line In

(Standard or

DSL)

From Network Device

(or Computer Using a

Crossover Cable)

From Modem

DSS or CATV Receiver

810 Install Connector Cover

(optional)

or DSL to Surge

Connect Network

Equipment

To Hub

or

Router

11 Connect to Power Source and Switch on UPS Power

Connect Equipment Power Cords

Hub

or Router

Modem

Network Device

Network Device

Output 1

Output 2

Output 3

Output 3

9

to Surge ProtectionProtection (optional)

Align the holes in the

cover with the connector

cover release tabs (one

each side) and lower

connector cover.

7 AMP

The line cord used for this connection is supplied

by the user.

NOTE: APC recommends your network equipment

(computer, modem, router, hub, or other networked

devices) be completely installed, configured, and

tested prior to adding this UPS to the network.

Product specificaties