Adastra WA-215 Handleiding

Adastra Speaker WA-215

Bekijk gratis de handleiding van Adastra WA-215 (10 pagina’s), behorend tot de categorie Speaker. Deze gids werd als nuttig beoordeeld door 75 mensen en kreeg gemiddeld 4.5 sterren uit 38 reviews. Heb je een vraag over Adastra WA-215 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/10

WA-215

Wall Mounted Amplifier with

USB/microSD/FM/BT Player

Item ref: .132UK, 953.137 953 UK

User Manual

Version 2.1

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

953.132 , 953.137UK User ManualUK

Introduction

Thank you for choosing the Adastra - -wall amplifier for your discreet audio WA 215 in

installation. This unit is designed to power wall or ceiling mounted speakers and receive audio

via Bluetooth. Please read this manual to gain the best results from your product and avoid

damage through misuse.

SAFETY SYMBOL AND MESSAGE CONVENTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS

RISQUE DE CHOC ELECTRIQUE NE PAS

OUVRIR

This symbol indicates that dangerous voltage constituting a risk of electric shock is

present within this unit

This symbol indicates that there are important operating and maintenance instructions in

the literature accompanying this unit.

Warning

To prevent the risk of fire or electric shock, do not expose any components to rain or

moisture. If liquids enter the housing, stop using immediately, allow unit to dry out and have

checked by qualified personnel before further use. Avoid impact, extreme pressure or heavy

vibration to the case.

No user serviceable parts inside Do not open the case refer all servicing to qualified – –

service personnel.

Safety

• This product is powered directly from the mains supply and should only be fitted by a

qualified electrical installer.

Placement

• The WA- 5 can be installed into a partition wall using the supplied pattress box. 21

• The WA-215 can be surface mounted if necessary, using the supplied back box.

• Ensure adequate ventilation and keep away from combustible material or moisture.

• Ensure that the WA- is within range of the sending device if using Bluetooth. 215

• Do not set the panel fully into the wall and ensure adequate access to the bottom edge.

Cleaning

• Use a soft cloth with a neutral detergent to clean the housing as required.

• Do not use solvents for cleaning the unit.

953.132 , 953.137UK User ManualUK

Loudspeaker Installation

The WA-215 wall amplifier is available separately or as a WA- -SET. 215

If supplied as a WA- -SET, there are 2 ceiling speakers supplied. 215

The speakers may be installed into a plasterboard or tiled ceiling with at least 80mm to

accommodate the mounting depth of each speaker.

The speakers should be wired to the WA-215 amplifier using standard twin speaker cable.

10m of suitable cable is supplied with the WA- -SET and should be cut as required. 215

Carefully mark out and cut a hole 170mm

diameter for each speaker.

Feed the speaker wires from each hole to the

WA-215 (passing through the back box)

Connect the + and - wires from the WA-215

speaker outputs to the 8Ω and COM screw

terminals and offer the speaker to the hole in

the ceiling with the spring clamps either side of

the magnet pressed fully up to fit through the

hole. The spring clamps will fold back down to

hold the speaker in place. (see opposite)

If the WA-215 is supplied without speakers, ensure that the load to be connected to each

speaker output has no lower than 8 impedance and has a power handling of 15W max. Ω

Do not connect further speakers as this can cause damage to the WA- amplifier circuitry. 215

Back box installation

The WA-215 is supplied with a single gang 60mm deep back box and mounting plate for flush

mounting or surface mounting to a wall. Install the back box to the chosen location and knock

out any of the pre-punched discs in the sides for cable access as required.

Screw the mounting plate into the front of the back box and feed power, speaker, trigger and

signal wires through the back box to the WA-215 and connect to the relative terminals.

(see “Connections” on the next page)

Alternatively, the mounting plate can be fitted into a standard 86 x 86mm pattress box top

accommodate the WA-215, so long as there is a minimum 47mm mounting depth

Product specificaties

Merk:	Adastra
Categorie:	Speaker
Model:	WA-215
Kleur van het product:	Wit
Gewicht verpakking:	1900 g
Breedte verpakking:	220 mm
Diepte verpakking:	530 mm
Hoogte verpakking:	80 mm
Stroombron:	AC
Bluetooth:	Ja
Aan/uitschakelaar:	Ja
Afstandsbediening:	Draadloos
Bluetooth-versie:	4.1
Connectiviteitstechnologie:	Bedraad en draadloos
Meegeleverde kabels:	Audio Direct
Aantal USB 2.0-poorten:	1
Gemiddeld vermogen:	30 W
Versterker output power:	30 W
Aanbevolen gebruik:	Universeel
Audio-uitgangskanalen:	2.0 kanalen
Op afstand bedienbaar:	Ja
Signaal/ruis-verhouding:	98 dB
Ondersteunde frequentiebanden:	FM
Totale harmonische vervorming (THD):	0.03 procent
Aantal satellieten:	2
Gemiddeld vermogen satelietluidsprekers:	15 W
Satellite speaker afmetingen (WxDxH):	76 x 188 x 188 mm
Satellite speaker gewicht:	700 g
Afstandsbediening inbegrepen:	Ja
AC-ingangsspanning:	100 - 240 V
AC-ingangsfrequentie:	50 - 60 Hz
Amplification device meegeleverd:	Ja
Versterker/ontvanger ingang interface type:	Bluetooth, USB
Amplification device type:	Versterker
Amplification device form factor:	Losstaand
Freqentiebereik satellietluidspreker:	100 - 15000 Hz
Versterker afmetingen (W x D x H):	86 x 86 x 50 mm