Valcom V-9953 Handleiding

Bekijk gratis de handleiding van Valcom V-9953 (4 pagina’s), behorend tot de categorie Intercomsysteem. Deze gids werd als nuttig beoordeeld door 35 mensen en kreeg gemiddeld 4.6 sterren uit 8 reviews. Heb je een vraag over Valcom V-9953 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

VSP-V-9953

Issue 4

1947210

V-9953

HANDSFREE TALKBACK PLUG-IN BOARD

INTRODUCTION

The V-9953, Handsfree Talkback Plug-In Board,

designed to be used with the V-2003A, allows the

V-2003A to be converted to a V-2003AHF to permit

handsfree operation.

These instructions contain the specifications and

information necessary to install and operate the

V-9953 used in conjunction with the V-2003A.

DIMENSIONS/WEIGHT

• 6.80" H x 4.75" W x 1.50" D

(17.27cm H x 12.07cm W x 3.81cm D)

• 1.0 lbs (.45 kg)

CONNECTIONS

The V-9953 can be purchased as an "add on" feature

after the initial purchase of a V-2003A. By adding a

V-9953, Handsfree Talkback Plug-In Board, the

V-2003A unit can be modified to a V-2003AHF.

The V-2003AHF is programmable on a per zone

basis for one-way or talkback communication. A

single zone may have both one-way and talkback

speakers. One-way speakers should be connected to

the low level outputs for zone 1 (R/BL pair), zone 2

(R/G pair) and zone 3 (R/S pair). These speakers will

act as one-way for the associated zone whether or not

the zone is programmed for one-way or talkback

paging.

If 45 Ohm speakers are connected to the handsfree

output and the zone is programmed for one-way, the

speakers will receive the page. The zone must be

programmed for talkback communication in order to

utilize the talkback option. The page volume control

located on the handsfree board regulates the volume

of the 45 Ohm talkback speakers under both these

circumstances.

Do not connect amplified speakers to the V-9953

talkback zones as they are already amplified.

__ 1. Unplug the V-2003A from the AC power

source; unplug the battery backup if one is

used.

__ 2. Remove the cover of the V-2003A unit by

first removing the four (4) - #32 screws that

attach the cover to the base.

__ 3. Plug the V-9953 board into the chassis of

the V-2003A. Insure the proper alignment

of all pins for proper fit and operation.

__ 4. Secure the V-9953 board to the V-2003A

chassis using the two (2) screws and

lockwashers provided.

__ 5. Insert the Phone-Speaker and Speaker-Phone

volume controls into the cover of the

V-2003A as shown in Figure 2. The control

with the long shaft is Phone to Speaker; the

control with the shorter shaft is Speaker to

Phone. Secure these controls with the

washers and nuts provided.

Make sure the tab on the body of the control

engages the enclosure.

__ 6. Replace the cover of the V-2003A unit.

Insert the four (4) - #32 screws and tighten

snugly to hold in place.

__ 7. Affix the enclosed label to the side of the

Product specificaties