Uline H-7093 Handleiding

Bekijk gratis de handleiding van Uline H-7093 (3 pagina’s), behorend tot de categorie Lamp. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.7 sterren uit 7 reviews. Heb je een vraag over Uline H-7093 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PAGE 1 OF 3 0623 IH-7093

π H-7093, H-7094

FORKLIFT STROBE LIGHT

1-800-295-5510

uline.com

PARTS

OPERATION

1. To operate, hardwire light to a switched power

source so light is either powered all times the truck is

on or when the forklift is put into drive or reverse.

NOTE: All hardwiring should be performed by

a qualified electrician. If unsure of the correct

electrical hookup location, contact local

forklift dealer. Length of wire needed will vary

by forklift. Extension wire may be necessary.

The negative (black) wire should connect to

negative side of the battery. On certain trucks,

this may be the frame. If you are uncertain

whether the frame is the negative/ground or

know that it is not, a separate wire lead will be

required to run directly to the negative battery

terminal or main negative/ground of the truck.

CAUTION! Do not connect the forklift strobe

light to the drive motor leads or coils on

electric trucks. Connection should be made

to control wiring only. Use a volt meter prior

to connecting the light to verify the voltage.

A steady voltage must be observed with any

spikes in voltage remaining within allowable

limits.

TOOLS NEEDED

Screwdriver

Pedestrian Safety Light x 1Mounting Plate x 1

(For Bolt-On Installation Only)

Bolt x 3

(For Bolt-On Installation Only)

Nut x 3

(For Bolt-On Installation Only)

INSTALLATION

FOR MAGNET MOUNTING

1. Attach strobe light to metal cage. (See Figure 1)

2. Ensure light is securely mounted before moving your

vehicle.

FOR BOLT-ON MOUNTING

1. Select a location to install strobe light.

2. Align mounting plate holes with strobe light holes on

opposite side of cage.

3. Use bolt and nut to connect strobe light through

mounting plate. Do not fully tighten. (See Figure 2)

4. Repeat with remaining two bolts and nuts.

5. Using screwdriver and 5/16" wrench, fully tighten all

three bolts and nuts.

Figure 1

Figure 2

Bolt

Nut

Mounting

Plate

5/16" Wrench

Para Español, vea página 2.

Pour le français, consulter la page 3.

Product specificaties