Uline H-3129 Handleiding

Bekijk gratis de handleiding van Uline H-3129 (3 pagina’s), behorend tot de categorie Lijmpistool. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.1 sterren uit 2 reviews. Heb je een vraag over Uline H-3129 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

0722 IH-3129

PAGE 1 OF 3

1-800-295-5510

uline.com

H-3129

5/8" HIGH PERFORMANCE

GLUE GUN

NOTE: The glue gun should be unplugged

after each use. The adhesive can be stored

indefinitely in the unheated gun and re-melted

by heating up the tool.

1. Use built-in screwdriver to adjust temperature control.

NOTE: The glue gun comes pre-set at 400°F.

2. Plug the glue gun into a 120 volt AC outlet; when red

light illuminates on/off switch, the power is on.

3. Insert 5/8" glue stick into glue feed. Allow the glue

gun to heat for approximately 3 to 5 minutes.

CAUTION! Once glue gun heats up, the nozzle

and melted glue are extremely hot. Avoid

touching.

4. When the gun is fully heated, squeeze trigger slowly.

The melted glue will begin to flow from nozzle.

Release the trigger to stop the glue flow.

5. The output volume of the glue can be adjusted by

turning the stroke adjuster clockwise.

NOTE: Use short nozzle for general use or long

nozzle for harder to reach areas.

6. If glue drips excessively, replace the nozzle. To

change, heat the gun for a minute until glue is

softened enough to remove the nozzle. While

wearing gloves, use a wrench to remove the old

nozzle. Flush glue through the gun and attach the

new nozzle.

OPERATION

SAFETY

Stroke Adjuster

On/Off Switch

Trigger

Temperature Control

Nozzle

Glue Feed

Power Input

1. Keep out of reach of children.

2. Never touch the gun's nozzle or the melted glue.

Operating temperatures reach 450°F and can cause

severe burns. Immediately immerse any accidental

burns in cold water and seek medical attention.

3. Do not use within 10 feet of flammable materials.

4. Not for outdoor use or in areas that may be wet or

damp.

5. Keep all work areas clean and well lit.

6. Never use with materials other than recommended

glue sticks.

7. Always wear protective safety equipment such as gloves,

glasses, and long sleeve shirts and pants when using.

8. When inserting glue sticks in glue gun, avoid using too

much force.

9. If the supply cord is damaged, it must be replaced by

the manufacturer or its service agent to avoid a hazard.

10. Always follow basic safety precautions when operating.

TOOL INCLUDED

Screwdriver (Built Into Base)

Para Español, vea página 2.

Pour le français, consulter la page 3.

Product specificaties