Taylor 1511 Handleiding

Bekijk gratis de handleiding van Taylor 1511 (4 pagina’s), behorend tot de categorie Weerstation. Deze gids werd als nuttig beoordeeld door 33 mensen en kreeg gemiddeld 4.5 sterren uit 5 reviews. Heb je een vraag over Taylor 1511 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

WeatherGuide™ System with Remote Sensor

Model 1511

Instruction Manual

Welcome to the Taylor® WeatherGuide™ System. Simple, reliable, accurate…it allows you to monitor indoor

or outdoor locations from one room. The base unit reads indoor conditions, while the remote sensor wirelessly

reports outdoor weather conditions back to the base unit for an all--one weather display.in

BATTERY INSTALLATION

The base unit operates on 2 AAA batteries and the remote sensor operates on 2 AAA batteries (batteries not

included). Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-

cad, ni-mh, etc.) batteries.

(Tip: Lithium batteries are recommended in extremely cold or hot locations.)

IMPORTANT: Install batteries in the base unit first, then the remote sensor, otherwise the units’ transmissions

may not properly connect. Place the base unit as close as possible to the remote sensor when installing batteries.

Base Unit

The battery compartment is located on the back of the unit. Remove the battery compartment door. Install (2)

AAA size batteries into the battery compartment according to the polarity markings. Replace the battery

compartment door.

Remote Sensor

The battery compartment is located under the table stand on the back of the unit. Pull up the table stand to access

the battery compartment. Remove the 4 screws from the battery compartment cover (take care not to misplace

the screws). Install (2) AAA size batteries into the battery compartment according to the polarity markings.

Replace the battery compartment door and the screws.

After Batteries are Installed:

Allow 3 minutes for the base unit to read current temperature conditions and connect with the remote sensor. A

transmission signal icon on the base unit during this time. After 3 minutes, the transmission (“”) flashes

signal will flash when a signal is received from the remote sensor.

The remote transmits temperatures once a minute. The red LED indicator light on the remote flashes when a

signal is sent.

Note: The outdoor temperature display on the base unit will display dashes (““) until the 1-- stremote sensor

signal is sent.

TEMPERATURE READINGS

The base unit displays the indoor temperature (“IN”) from its location.

The remote unit transmits outdoor temperature (“OUT”) from its location back to the base unit.

Press the C“° /°F” button on the base unit to switch between Fahrenheit or Celsius temperature displays.

Product specificaties