Star Micronics TSP1000 Handleiding
Star Micronics
Printer
TSP1000
Lees hieronder de 📖 handleiding in het Nederlandse voor Star Micronics TSP1000 (156 pagina's) in de categorie Printer. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/156
THERMAL PRINTER
TSP1000 SERIES
USER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
MANUALE DI ISTRUZIONI
Federal Communications Commission
Radio Frequency Interference
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
This statement will be applied only for the equipments marketed in U.S.A.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
For compliance with the Federal Noise Interference Standard, this equipment requires a
shielded cable.
For RF interference suppression, if a ferrite core is provided with this device, affix it to the
interface cable.
Statement of
The Canadian Department of Communications
Radio Interference Regulations
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
The above statement applies only to printers marketed in Canada.
Trademark acknowledgments
TSP1000: Star Micronics Co., Ltd.
ESC/POS: Seiko Epson Corporation
Notice
•All rights reserved. Reproduction of any part of this manual in any form whatsoever,
without STAR’s express permission is forbidden.
•The contents of this manual are subject to change without notice.
•All efforts have been made to ensure the accuracy of the contents of this manual at the
time of going to press. However, should any errors be detected, STAR would greatly
appreciate being informed of them.
•The above notwithstanding, STAR can assume no responsibility for any errors in this
manual.
© Copyright 2004-2009 Star Micronics Co., Ltd.
ENGLISH
TABLE OF CONTENTS
1. Unpacking and Installation .......................................................................................... 1
1-1. Unpacking .......................................................................................................................... 1
2. Parts Identification and Nomenclature ....................................................................... 2
3. Consumable Parts and AC Adapter ............................................................................ 4
4. Connecting Cables and AC Adapter ........................................................................... 6
4-1. Interface Cable ................................................................................................................... 6
4-2. Connecting to a Buzzer Drive .......................................................................................... 10
4-3. Connecting the Optional AC Adapter .............................................................................. 11
4-4. Turning Power On ........................................................................................................... 12
4-5. Installing the Cable .......................................................................................................... 13
4-6. Switch Blind Installation ................................................................................................. 14
5. Control Panel and Other Functions ........................................................................... 15
5-1. Control Panel ................................................................................................................... 15
5-2. Errors ............................................................................................................................... 15
5-3. Self Printing ..................................................................................................................... 17
6. Loading the Roll Paper ............................................................................................... 18
6-1. Loading the Roll Paper .................................................................................................... 18
6-2. Paper Loading Methods ................................................................................................... 21
6-3. Roll Paper Holder Adjustment ......................................................................................... 22
6-4. Paper Guide Adjustment .................................................................................................. 23
6-5. Upper Guide Adjustment ................................................................................................. 24
7. Adjusting the Near-end Sensor .................................................................................. 25
8. Preventing and Clearing Paper Jams ........................................................................ 27
8-1. Preventing Paper Jams ..................................................................................................... 27
8-2. Removing Paper Jam ....................................................................................................... 27
8-3. Releasing a Locked Cutter ............................................................................................... 28
9. Periodical Cleaning ..................................................................................................... 30
9-1. Cleaning the Thermal Head ............................................................................................. 30
9-2. Cleaning the Paper Holder ............................................................................................... 30
Appendix A: Specifications ........................................................................................... 128
A-1. General Specifications ................................................................................................... 128
A-2. Auto Cutter Specifications ............................................................................................. 129
A-3. Interface ......................................................................................................................... 129
A-4. Electrical Characteristics ............................................................................................... 129
A-5. Option ............................................................................................................................ 129
A-6. Environmental Requirements ........................................................................................ 130
A-7. Reliability ....................................................................................................................... 130
A-8. Black Mark Specifications ............................................................................................. 131
Appendix B: Dip Switch Setting................................................................................... 134
B-1. Parallel Interface Model ................................................................................................. 135
B-2. Sperial Interface (RS-232C) Model ............................................................................... 136
B-3. USB Interface Model ..................................................................................................... 138
B-4. Ethernet Interface Model ............................................................................................... 139
B-5. Wireless LAN Interface Model...................................................................................... 141
Appendix C: Parallel Interface .................................................................................... 144
Appendix D: Serial Interface (RS-232C)..................................................................... 145
D-1. RSConnector .................................................................................................................. 145
D-2. Cable Connections ......................................................................................................... 147
D-3. Electrical Characteristics ............................................................................................... 147
Appendix E: USB, Ethernet and Wireless LAN Interface ........................................ 148
E-1. USB Interface Specifications ............................................................................................ 148
E-2. Ethernet Interface Specifications ...................................................................................... 148
E-3. Wireless LAN Interface Specifications ............................................................................ 148
Appendix F: Buzzer Driver Circuit ............................................................................. 149
Appendix G: Memory Switch Settings ........................................................................ 151
Product specificaties
| Merk: | Star Micronics |
| Categorie: | Printer |
| Model: | TSP1000 |
Heb je hulp nodig?
Als je hulp nodig hebt met Star Micronics TSP1000 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Printer Star Micronics
7 Juli 2023
19 Juni 2023
16 Juni 2023
15 Juni 2023
15 Juni 2023
12 Juni 2023
6 Juni 2023
6 Juni 2023
5 Juni 2023
4 Juni 2023
Handleiding Printer
- Printer HP
- Printer Sony
- Printer Samsung
- Printer Xiaomi
- Printer Panasonic
- Printer Epson
- Printer LG
- Printer Huawei
- Printer Canon
- Printer Honeywell
- Printer Olympus
- Printer Toshiba
- Printer Xerox
- Printer Brother
- Printer Builder
- Printer Dell
- Printer Digitus
- Printer Dymo
- Printer Frama
- Printer Fujifilm
- Printer Fujitsu
- Printer Ibm
- Printer Intermec
- Printer Kodak
- Printer Konica Minolta
- Printer Kyocera
- Printer Lenovo
- Printer Lexmark
- Printer Minolta
- Printer Mitsubishi
- Printer MSI
- Printer Nec
- Printer Paxar
- Printer Polaroid
- Printer Primera
- Printer Renkforce
- Printer Ricoh
- Printer Roland
- Printer Royal Sovereign
- Printer Sagem
- Printer Seiko
- Printer Sharp
- Printer Star
- Printer Thomson
- Printer Tomy
- Printer Toshiba TEC
- Printer Triumph-Adler
- Printer Velleman
- Printer Zebra
- Printer Oce
- Printer Oki
- Printer Olivetti
- Printer Olympia
- Printer Argox
- Printer DTRONIC
- Printer Metapace
- Printer Citizen
- Printer Nilox
- Printer Approx
- Printer Ultimaker
- Printer Bixolon
- Printer Brady
- Printer GoDEX
- Printer Testo
- Printer EC Line
- Printer Pantum
- Printer DNP
- Printer TSC
- Printer Equip
- Printer StarTech.com
- Printer Fichero
- Printer GG Image
- Printer Posiflex
- Printer ZKTeco
- Printer Datamax-O'neil
- Printer Panduit
- Printer Dascom
- Printer HiTi
- Printer Vupoint Solutions
- Printer Elite Screens
- Printer Phoenix Contact
- Printer Colop
- Printer Raspberry Pi
- Printer Evolis
- Printer IDP
- Printer Fargo
- Printer Microboards
Nieuwste handleidingen voor Printer
26 April 2024
26 April 2024
26 April 2024
17 April 2024
17 April 2024
9 April 2024
9 April 2024
8 April 2024
8 April 2024
5 April 2024