Sharp AL-2051 Handleiding

Sharp Printer AL-2051

Lees hieronder de 📖 handleiding in het Nederlandse voor Sharp AL-2051 (44 pagina's) in de categorie Printer. Deze handleiding was nuttig voor 32 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/44

MODEL : AL-2051

DIGITAL MULTIFUNCTIONAL SYSTEM

START GUIDE

DIGITALES MULTIFUNKTIONSGERÄT

STARTANLEITUNG

SYSTEME MULTIFONCTIONS NUMERIQUE

GUIDE DE DEMARRAGE

DIGITAAL MULTIFUNCTIONEEL SYSTEEM

STARTERSGIDS

COPIADORA LÁSER DIGITAL

GUÍA DE INICIO

SISTEMA MULTIFUNZIONALE DIGITALE

GUIDA DI BASE

DIGITALT SYSTEM MED FLERE FUNKTIONER

STARTVEJLEDNING

DIGITAALINEN MONITOIMIJÄRJESTELMÄ

ALOITUSOPAS

DIGITALT MULTIFUNKSJONSSYSTEM

STARTVEILEDNING

DIGITALT MULTIFUNKTIONSSYSTEM

STARTMANUAL

Required in IEC-950 (EN 60 950) - Europe

• The equipment should be installed near an accessible socket outlet for easy disconnection.

Required in Appendix ZB of BS 7002 (En 60 950) — United Kingdom

MAINS PLUG WIRING INSTRUCTIONS

The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable

(moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse

to BS1362 marked or and of the same rating as the one removed from the plug must

be used.

Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without

the fuse cover fitted.

In the unlikely event of the socket outlet in your home not being compatible with the plug supplied

either cut-off the moulded plug (if this type is fitted) or remove by undoing the screws if a rewireable

plug is fitted and fit an appropriate type observing the wiring code below.

DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately

and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted

elsewhere into a 13A socket outlet as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

GREEN-AND-YELLOW: Earth

BLUE: Neutral

BROWN: Live

As the colours of the wires in this mains lead may not correspond with coloured markings

identifying the terminals in your plug, proceed as follows:

The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug

which is marked with the letter E, or by the safety earth symbol Å@, or coloured green or green-

and-yellow.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter

N or coloured black.

The wire which is coloured BROWN must be connected to the terminal which is marked with the

letter L or coloured red.

If you have any doubt, consult a qualified electrician.

WARNING: THIS APPARATUS MUST BE EARTHED.









DIGITAL MULTIFUNCTIONAL SYSTEM

START GUIDE

MODEL: AL-2051

This guide explains how to install the machine, and indicates important points to note for installation and usage. Read and understand this guide to ensure

that you install the machine correctly. The Operation Guide for the machine is on the accompanying CD-ROM. The procedure for viewing the guide is

explained in "6. HOW TO USE THE OPERATION GUIDE". After installation, read the Operation Guide to make full use of all the machine has to offer.

1. CHECKING PACKED COMPONENTS AND

ACCESSORIES

Open the carton and check if the following components and accessories

are included.

If anything is missing or damaged, contact your authorized service

representative.

PREPARING THE MACHINE FOR

INSTALLATION

3. INSTALLING THE TD (TONER DEVELOPER) CARTRIDGE

If the machine does not function properly during setup or use,

or if a function cannot be used, see "TROUBLESHOOTING

AND MAINTENANCE" (p.137).

CD-ROM

Drum cartridge

(installed in unit)

TD cartridge

Power cord

START GUIDE

1Be sure to hold the handles on both

sides of the machine to unpack the

machine and carry it to the installation

location.

2Remove all pieces of tape shown in the illustration below and then open

the RSPF and remove the protective materials. Take out the bag

containing the TD cartridge.

1Open the bypass tray, and

then open the side cover. 2Press gently on both

sides of the front cover to

open the cover.

3Remove the TD cartridge from the bag. Hold the

cartridge on both sides and shake it horizontally

four or five times. Hold the tab of the protective

cover and pull the tab to your side to remove the

cover.

While pushing the lock

release button, gently

insert the TD cartridge

until it locks into place.

5Close the front cover and then the side cover by pressing the

round projections near the side cover open button. 6Ensure that the power switch of the

unit is in the OFF position. Insert the

attached power cord into the power

cord socket at the rear of the unit.

Plug the other end of the power cord

into the nearest outlet.

Only insert the power cord

into a properly grounded wall

socket.

Do not use extension cords or

power strips.

When closing the covers, be sure to close the front cover

securely and then close the side cover. If the covers are

closed in the wrong order, the covers may be damaged.

4 or 5 times

Lock release button

Product specificaties

Merk:	Sharp
Categorie:	Printer
Model:	AL-2051
Ingebouwd display:	Ja
Gewicht:	18500 g
Stroomvoorziening:	220-240V, 50/60Hz
Beeldscherm:	LCD
USB-poort:	Ja
Ethernet LAN:	Ja
Geïntegreerde geheugenkaartlezer:	Nee
Markt positionering:	Bedrijf
Aantal USB 2.0-poorten:	1
Intern geheugen:	64 MB
Duurzaamheidscertificaten:	ENERGY STAR
Tekstregels:	2 regels
Soort voeding:	AC
Compatibele besturingssystemen:	Windows 2000/XP, Windows Server 2003/\n2008, Windows Vista, Windows 7
Maximale resolutie:	600 x 600 DPI
Papierlade mediatypen:	Normaal papier
Standaard interfaces:	USB 2.0
Printsnelheid (zwart, standaardkwaliteit, A4/US Letter):	20 ppm
Printen:	Zwart-wit afdrukken
Duplex printen:	Nee
Gebruiksindicatie (maximaal):	- pagina's per maand
Digital Sender:	Nee
Kopieën vergroten/verkleinen:	25 - 400 procent
Tijd voor eerste kopie (zwart, normaal):	8 s
Maximale kopieerresolutie:	600 x 600 DPI
Kopiëren:	Zwart-wit kopiëren
Scannen:	Mono-scannen
Optische scanresolutie:	600 x 600 DPI
Faxen:	Nee
Totale invoercapaciteit:	300 vel
Maximum invoercapaciteit:	300 vel
Totale uitvoercapaciteit:	- vel
Maximale ISO A-series papierformaat:	A4
ISO A-series afmetingen (A0...A9):	A4,A5,A6
Gemiddeld stroomverbruik ( bedrijfsresultaat ):	1000 W
Maximaal intern geheugen:	128 MB
Maximale printafmetingen:	210 x 297 mm
A6 Card:	Ja
Grijsniveaus:	256
Duplex scannen:	Nee
Maximaal aantal kopieën:	99 kopieën
Dubbelzijdig kopiëren:	Nee
Dubbelzijdig faxen:	Nee
Meegeleverde drivers:	Ja
Afmetingen (B x D x H):	518 x 460 x 376 mm
Ondersteunde gewicht(en) media:	56 - 128 g/m²
All-in-one-functies:	Copy,Print,Scan
Kleurenfuncties all-in-one:	Nee
Wifi:	Nee
Emulatie:	PLC