Robert Abbey D1988 Handleiding

Bekijk gratis de handleiding van Robert Abbey D1988 (1 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.2 sterren uit 8 reviews. Heb je een vraag over Robert Abbey D1988 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

ASSEMBLY INSTRUCTIONS FOR YOUR

1988

ASSEMBLY INSTRUCTIONS:

(E)

FIGURE A

(A)

(F)

(G)(H)

(B)

(E)

(C)

OUTLET

BOX

(D)

(I)

(I)

(J)

(K)

(J)

(K)

10. Lift backplate (A) to outlet box and make proper electrical connection. A licensed electrician is recommended.

11. Attach ground wire from xture (green or copper in color) to ground wire from outlet box.

12. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire

nut (D) and tightly wrap connection with electrical tape.

13. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with

wire nut (D) and tightly wrap connection with electrical tape.

14. Gently push wires back into outlet box.

15. Afx back plate (A) to outlet box using mounting screws (C) provided. Thread screws (J) into wall anchors (K).

16. Insert six (6) 60W MAX B-11 Torpedo bulbs into sockets (provided).

17. Carefully close metal frame (B), making sure it connects securely with backplate (A).

Caution: To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.

1. SHUT OFF ELECTRICAL SUPPLY FROM MAIN FUSE

BOX / CIRCUIT BREAKER.

2. Remove all parts from carton. Do not throw away any parts.

3. Set backplate (A) on level surface. Carefully open metal frame

(B).

4. Remove shade stop (F) from one side of metal frame (B) by

removing screws (H) and washers (G). NOTE: Both sides of metal

frame (B) have a shade stop. Only remove one shade stop.

5. Align glass shade (E) with metal frame (B). Carefully rotate

glass shade (E) into metal frame (B) as shown in FIGURE A.

NOTE: One side of glass shade (E) should rest against step on

shade stop remaining in metal shade (B). Repeat step for each

glass shade.

6. Align loose shade stop (F) with glass shades (E), making sure

step on shade stop (F) rests securely against edges of installed

glass shades (E).

7. Align washers (G) with holes in shade stop (F) and metal frame

(B). Insert screws (H) through openings in washers (G) and shade

stop (F) into threaded holes in metal frame (B).

NOTE: Fixture can be mounted in vertical position or horizontal

position.

8. Lift xture to outlet box. Hold xture in the desired location and

mark holes for frame support holes (I).

9. Gently place xture on at surface. Use screws (J) provided to

make pilot holes in the wall. Remove screw (J) from pilot hole.

Using a hammer (not provided) carefully install wall anchors (K)

into the vacant holes.

IMPORTANT SAFETY INSTRUCTIONS:

*These instructions are provided for your safety. It is very important

that they are read completely before beginning the installation of

your xture.

*WE STRONGLY RECOMMEND INSTALLATION BY A

LICENSED ELECTRICIAN.

*Turn off power at switch before replacing bulbs, making sure

xture has had sufcient time to cool down.

*DO NOT subject the xture to any shock while lit as

shattering of bulbs may result.

CHASE 36”

BATH SCONCE

Product specificaties