ResMed SlimLine Tubing Wrap Handleiding

Bekijk gratis de handleiding van ResMed SlimLine Tubing Wrap (26 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 6 mensen en kreeg gemiddeld 4.1 sterren uit 7 reviews. Heb je een vraag over ResMed SlimLine Tubing Wrap of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Tubing Wrap

STANDARD AND SLIMLINE

User Instructions

English • • Deutsch • • Français • • Italiano • • Español • • Português • • Nederlands • • Svenska • • Dansk • • Norsk • • Suomi • • 简体中文 • •

繁體中文

• • Български •• Hrvatski •• Čeština •• Eesti ••λληνικά •• Magyar •• Íslenska •• Latviski •• Lietuvių k. •• Polski •• Română ••

Русский

•• Slovenčina •• Slovenščina •• Türkçe ••



••



•• תירבע ••



English

The tubing wrap is intended to reduce condensation

and temperature loss in ResMed air tubing when

connected to a device.

The tubing wrap is available in two variants, Standard

(33963) and SlimLine (36811), referred to collectively

as ‘tubing wrap’ throughout this manual.

CodeColourLengthDiameter

33963Blue2 m19 mm

36811Grey1.8 m15 mm

Fitting

1. Fully unzip the tubing wrap and unfasten the

Velcro

™

strap.

2. Lay the tubing wrap down with the inside

facing up.

3. Pass one end of the air tubing through the closed

zipper end of the tubing wrap until the rubber

cuff is through.

4. Hold the rubber cuff in position, then zip up the

tubing wrap.

5. Fold the extended end of the zipper back against

the tubing wrap and secure using the Velcro

strap. Only the rubber cuffs should now be

visible.

Note: If you have a Standard tubing wrap and you

want to use it with SlimLine air tubing, you must

complete this additional step between steps 3 and 4:

•At the open end of the tubing wrap, fold the

extra length over by approximately 15 cm and

secure using the Velcro.

WARNING

Do not use the tubing wrap if the room

temperature is above 30°C. At higher

temperatures the air temperature at the mask

may be too hot.

Note: For any serious incidents that occur in relation

to this device, these should be reported to ResMed

and the competent authority in your country.

Note: If you notice any unexpected changes in the

device, signs of degradation that affect performance

or if the enclosure is broken, discontinue use and

contact your Health Care Provider.

Cleaning instructions

The tubing wrap should be hand washed or dry

cleaned only. Wash the tubing wrap separately when

new, as the colour may run. Do not bleach.

To wash the tubing wrap:

1. Wash in cold to warm water using a mild

detergent.

2. Rinse well and drip dry.

Note:Hand washing your tubing wrap does not

replace the need to clean your air tubing.

Disposal

The tubing wrap and packaging does not contain any

hazardous substances and may be disposed of with

your normal household refuse.

Technical specifications

Storage and transport temperature: -20°C to 60°C

Storage and transport humidity: 5 to 95% non-

condensing

Symbols

The following symbols may appear on your tubing

wrap or packaging.

Warning; Consult instructions for use;

Manufacturer; European Authorised

Representative;

REF

Catalogue Number; Batch

Code; Importer; Medical device;

Temperature limitation. See symbols glossary at

www.resmed.com/symbols

Product specificaties