Projecta HDBT254 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Projecta HDBT254 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
P/No. HDBT254
Tray Fitting Instructions to suit Auxiliary battery for
Ford Ranger PX 2011/Mazda BT50 2011
Years: Ford/Mazda 2011 onwards
Models: Ford Ranger PX/Mazda BT50 B32P
HEAVY DUTY DUAL BATTERY TRAY
2
IMPORTANT SAFETY INFORMATION
Please read this instruction thoroughly before fitting the tray.
This product is recommend to be fitted by a workshop or qualified mechanical person.
WARNINGS
• Before installation, make sure that the vehicle is stationary and the wheels chocked.
• Be careful when laying wires, not to cause any electrical shorts or wire breakage.
• After installation ensure the bonnet can close without hitting the newly installed battery
and battery tray.
SPECIFICATIONS
Max Battery Size (mm) L326 x W165x H242
Max Battery Weight 27.2Kg
Recommended batteries Optima D31A
Approximate fitting time 2 hours
Special tools None required
Recommended Dual DBC150, VSR200 or IDC25
Battery System
Tray Location Under the body, passengers side of chassis rail
KIT INCLUDES
Hardware
1 x M8 Bolt
1 x M8 Spring Washer
4 x M12 Bolts (Chassis Bolts)
4 x M12 Nylock Nuts
4 x M12 Washers
2 x Chassis
Plates
Tray
Hold Down
Top Mount
1. Make sure that the vehicle is stationary, the engine is switched off and cool.
Disconnect the negative battery terminals from the main battery.
2. Remove the 4 bolts holding the transfer box guard and remove the guard,
replace after installing battery tray and battery.
3. Position tray as close as possible to fuel tank guard and using M12 bolts, nylock
nuts and washer secure tray to chassis rail. Using 2 X chassis plates supplied.
No holes are required as the bolts are over and under the Chassis rail.
4. Check clearance of fuel lines and brake lines. Shroud fuel and brake lines with split
tubing where they pass over the top bracket.
5. Install battery and ensure clearance to fuel tank and secure battery.
Using M8 bolt and spring washer fit the hold down top mount.
6. Reconnect the negative battery terminal to the main starter battery or install
the desired Dual Battery System.
For assistance throughout the installation procedure please call our customer service
representatives on 1800 113 443.
3
FITTING INSTRUCTIONS


Product specificaties

Merk: Projecta
Categorie: Niet gecategoriseerd
Model: HDBT254

Heb je hulp nodig?

Als je hulp nodig hebt met Projecta HDBT254 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Projecta

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd