Projecta HDBT120 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Projecta HDBT120 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Tray Fitting Instructions to suit Auxiliary battery for
TOYOTA LANDCRUISER 200 DS SERIES
Years: September 2016 onwards
Models: 1VD-FTV 4.5 Litre V8 Turbo Diesel
HEAVY DUTY DUAL BATTERY TRAY
P/No. HDBT120
2
IMPORTANT SAFETY INFORMATION
Please read this instruction thoroughly before fitting the tray.
This product is recommend to be fitted by a workshop or qualified mechanical person.
WARNINGS
• Before installation, make sure that the vehicle is stationary and the wheels chocked.
• Be careful when laying wires, not to cause any electrical shorts or wire breakage.
• After installation ensure the bonnet can close without hitting the newly installed battery
and battery tray.
• Ensure original parts and pipes have sufficient clearance from the tray and battery.
Push them away from the tray if required.
SPECIFICATIONS
Max Battery Size (mm) L300x W174 x H220
Max Battery Weight 28Kg
Recommended batteries Exide LCS27-97and Century NS70TMF
Approximate fitting time 30 minutes
Recommended Dual P/No: IDC25, DBC150, VSR200
Battery System
Tray Location Engine Bay, Drivers Side Front
KIT INCLUDES
Hardware
2 x M6 Countersunk Bolts
1 x M8 Bolt
2 x J Bolts
Special Top
Mount
J Bolts
Tray
3
FITTING INSTRUCTIONS
1. Make sure that the vehicle is stationary, the engine is switched off and cool
Disconnect the negative terminal from the main battery.
2. Locate the tray behind the driver’s side headlight.
3. Locate the two captive nuts with the two holes in the tray and secure with the
2 x M6 countersunk bolts.
4. Remove the radiator cover panel, replace after battery secured.
5. Fit Auxiliary battery.
6. Place the Special Top Mount to secure the battery with the J Bolts and bolt the
front of the Special Top Mount to the radiator support panels using the M8 Bolt
to the captive nut on the panel.
7. Use the factory J bolt mount near the air cleaner in place of the hole in the tray.
8. Replace radiator cover panel.
9. Reconnect the negative battery terminal to the main starter battery. Before closing
the bonnet make sure the battery and tray does not hit the bonnet.
For assistance throughout the installation procedure please call our customer service
representatives on 1800 113 443.


Product specificaties

Merk: Projecta
Categorie: Niet gecategoriseerd
Model: HDBT120

Heb je hulp nodig?

Als je hulp nodig hebt met Projecta HDBT120 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Projecta

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd