Ozito BSW-2581 Handleiding

Ozito Zaagmachine BSW-2581

Lees hieronder de 📖 handleiding in het Nederlandse voor Ozito BSW-2581 (12 pagina's) in de categorie Zaagmachine. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
1
BAND SAW
250W 200mm (8”)
Setup & Adjustment Manual
BSW-2581
0717
1. Tensioning Knob
2. Upper Blade Pulley
3. Upper Door
4. ON/OFF Switch
5. Lower Door
6. Rip Fence
7. Rip Fence Locking Lever
8. Lower Blade Pulley
9. Upper Door Lock
10. Blade Guard Adjustment
11. Blade Guard
12. Upper Blade Guide
13. Saw Table
14. Stabiliser Bar
15. Lower Door Lock
16. Machine Base
BAND SAW
2
CONTENTS
KNOW YOUR PRODUCT
KNOW YOUR PRODU
Know your product .............................................................................................................. Page 2,3
Fitting the rubber feet & stabiliser bar.................................................................................. Page 4
Fitting the blade................................................................................................................... Page 4
Tensioning the blade for tracking......................................................................................... Page 5
Adjusting the blade (tracking).............................................................................................. Page 6
Tensioning the blade for use................................................................................................ Page 7
Setting blade guides............................................................................................................ Page 7
Mounting the saw table........................................................................................................ Page 9
0
I
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
4
Rubber Feet
1. Insert one of the hex head bolts with a washer into 1 of 4 holes in
the base of the machine.
2. Align one of the rubber feet and nut with the bolt from underneath
the base and hand tighten.
3. Tighten the hex head bolt with a spanner to secure the rubber
foot.
4. Repeat this process to attach the remaining 3 rubber feet.
Stabilising Bar
1. Insert the rails of the stabilising bar into the 2 holes in the side of
the machine base.
2. Align the 2 holes in the stabilising bar with the holes in the
machine base.
3. Insert the 2 stabilizer bar bolts with washer through the aligned
holes and secure with the nuts.
4. Tighten to secure the stabilising bar.
SETUP & PREPARATION
IMPORTANT! ENSURE THE TOOL IS DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING OPERATIONS.
1. FITTING THE RUBBER FEET & STABILISER BAR
2. FITTING THE BLADE
Before adjusting the tension & tracking of the blade, please ensure the upper & lower guides
are well clear of the blade (following the steps below).
1. Loosen the door locking knobs and open both housing doors.
2. Remove the left blade guard by sliding it up and out. Also open
the right blade cover.
3. Loosen the tensioning knob at the top of the unit by rotating
anti-clockwise.
0
I


Product specificaties

Merk: Ozito
Categorie: Zaagmachine
Model: BSW-2581

Heb je hulp nodig?

Als je hulp nodig hebt met Ozito BSW-2581 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Zaagmachine Ozito

Handleiding Zaagmachine

Nieuwste handleidingen voor Zaagmachine